Cisco OL-4015-08 Bedienungsanleitung Seite 651

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 678
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 650
1003
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(30)S
The image or file is copied over successfully to the PC flash card, but it takes about three times
longer than usual.
Conditions: This symptom is observed on a Cisco platform that has a processor that runs at a low
speed.
Workaround: If the file is small, it may be copied to bootflash. There is no other workaround.
CSCef27191
Symptoms: It is not possible to change the duplex configuration to full duplex on a Fast Ethernet
(FE) interface of a Cisco 7200 series. When you enter the full-duplex interface configuration
command, the command is ignored. The parser accepts the command, but it is not shown in the
output of the show running-config command and the output of the show interface command shows
the FE interface as half-duplex.
Conditions: This symptom is observed when the FE interface belongs to a PA-2FEISL-FX or
PA-2FEISL-TX port adapter and when the Cisco 7200 series runs Cisco IOS Release 12.0(28)S or
a later release.
Workaround: There is no workaround.
CSCef27197
Symptoms: OAM emulation does not function on an interworking connection.
Conditions: This symptom is observed when OAM emulation is enabled on an AAL5 connection
between a CE router and a PE router when this AAL5 connection is configured for interworking.
The PE router receives the OAM cells but drops them, and the ATM PVC on the CE router is down.
Workaround: There is no workaround.
CSCef27580
Symptoms: Policy-based routing (PBR) loadsharing does not occur.
Conditions: This symptom is observed on a Cisco 12000 series when PBR loadsharing is enabled
via the set next-hop recursive command and when routes to the destination are available via
multiple interfaces. When you enter the shutdown interface configuration command followed by the
no shutdown interface configuration command on the interface that connects to the next-hop (or
when the interface goes down and comes back up), traffic does not resume on this interface.
Workaround: Enter the static arp command on the interface that connects to the next-hop.
CSCef27796
Symptoms: A router may crash when you create an ATM subinterface.
Conditions: This symptom is observed on a Cisco router that runs a Cisco IOS interim release for
Release 12.0(30)S when you quickly create an ATM subinterface and enter the mpls ip command
on the interface. Note that this caveat is resolved in Release 12.0(30)S.
Workaround: There is no workaround.
CSCef28765
Symptoms: An error message similar to the following one (in which the tunnel interface is a Generic
Routing Encapsulation [GRE] tunnel) and a traceback may be generated:
%IPFAST-2-PAKSTICK: Corrupted pak header for Tunnel8, flags 0x20
In addition, connectivity problems may occur.
Conditions: These symptoms are observed on a router that runs Multiprotocol Label Switching
(MPLS) over a GRE tunnel and that advertises an explicit null label.
Workaround: Do not use an explicit null label. Rather, use the default implicit null label.
Seitenansicht 650
1 2 ... 646 647 648 649 650 651 652 653 654 655 656 ... 677 678

Kommentare zu diesen Handbüchern

Keine Kommentare