Cisco OL-4015-08 Bedienungsanleitung Seite 187

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 678
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 186
539
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(32)S9
Conditions: This symptom is observed on a Cisco router when you first perform and OIR of a VIP
in which a port adapter is installed that supports both T1 and E1 (for example, a PA-MC-8TE1+ port
adapter) and then an SSO switchover occurs.
Workaround: There is no workaround. You must power-cycle the standby RP to enable it to come up.
CSCin98630
Symptoms: When an InARP request is received on an AAL5SNAP PVC, the router does not respond
with an InARP reply.
Conditions: This symptom has been observed when the source address contained in InARP request
is not in the subnet of the sub-interface on which PVC is configured.
Workaround: There is no workaround.
CSCir02303
Symptoms: InARP map gets deleted and ping does not work.
Conditions: This problem is seen when there is P2P on one side and multipoint on the other. The
map is deleted on the multipoint side, and the inARP configuration is changed on P2P side.
Workaround: There is no workaround.
CSCsa83219
Symptoms: Configuring an SDCC interfaces on a 2xOC48 POS SPA on the Cisco 12000 Series
platform causes the router to display the following error message.
"%EELC_QOS_RES_MGR-3-HW_IDB_INDEX_TO_TX_PORT_MAPPING_FAILED:
Mapping of hwidb_index to tx_port failed. hwidb_index = 5"
The message is displayed every time and SDCC interface is configured for this SPA. There is no
other adverse effect other than the message being displayed.
Conditions: This symptom is observed on a Cisco 12000 series router that is running Cisco IOS
Release 12.0(32)S.
Workaround: There is no workaround.
CSCsc45827
Symptoms: T1/e1 stay up when BERT is running.
Conditions: BERT once started, cannot be stopped.
Workaround: Reload the SPA.
CSCsd97412
Symptoms: LC gets reset.
Conditions: SPABRG generates excessive interrupts.
Workaround: There is no workaround.
CSCse34197
Symptoms: Ping fails to remote CE.
Conditions: This symptom occurs after edge interface on a PE is micro reloaded, for example 4t3/e3
serial interface with PPPoMPLS AToM circuit.
Workaround: Try one of the following workarounds:
1. Reload the SPA.
2. Remove and reapply xconnect configuration.
Seitenansicht 186
1 2 ... 182 183 184 185 186 187 188 189 190 191 192 ... 677 678

Kommentare zu diesen Handbüchern

Keine Kommentare