Cisco OL-4015-08 Bedienungsanleitung Seite 415

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 678
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 414
767
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(31)S3
You enter an interface configuration command that enables IS-IS such as an isis command, a
clns command, or the ipv6 router isis before you enter the a router configuration command
such as the net command.
When you now remove the IS-IS configuration at the interface or router level, the router may reload.
Workaround: Remove the isis protocol shutdown interface configuration command before you
remove IS-IS from the interface or router level.
Miscellaneous
CSCeg24422
Symptoms: Packet drops occur in the ingress direction on a dMLP or dMLFR link with traffic at
95-percent of the line rate and when the number of packets with a small size is high.
Conditions: This symptom is observed on a Cisco 7500 series that functions as a provider edge (PE)
router, that is configured for L2TPv3 L3VPN, and that has dMLP or dMLFR links to a customer
edge (CE) router.
Workaround: There is no workaround.
CSCeg57219
Symptoms: You cannot ping with packets of certain sizes after an RPR+ switchover or after an
interface flap on a multilink interface that has members of non-channelized port adapters when the
multilink interface is configured with fragmentation and interleaving.
Conditions: This symptom is observed on a Cisco 7500 series and Cisco 7600 series.
Workaround: There is no workaround.
CSCeg76795
Symptoms: L2TPv3 sessions are re-established after their L2TP class has been deleted.
Conditions: This symptom is observed when you enter the no l2tp-class global configuration
command to delete the class that is used by existing Xconnect paths via a pseudowire class.
Workaround: Remove the Xconnects paths along with the L2TP class.
CSCeh32706
Symptoms: An inter-AS TE LSP fails to send a signal after a router is rebooted as an ASBR.
Conditions: This symptom is observed when there are parallel links between ASBRs with a
combination of point-to-point and broadcast interfaces that are configured with the MPLS Traffic
Engineering--Inter-AS TE feature and (passive) link flooding.
Workaround: Shut down the broadcast interface between the ASBRs.
CSCeh62351
Symptoms: A router or line card may reload when you enter any of the following commands:
On a Cisco 7304:
show tech-support command.
show hw-module subslot all status command.
show hw-module subslot slot-number/subslot-number status command.
On a Cisco 7600 series or Cisco 12000 series:
show tech-support command.
show hw-module subslot all status command.
Seitenansicht 414
1 2 ... 410 411 412 413 414 415 416 417 418 419 420 ... 677 678

Kommentare zu diesen Handbüchern

Keine Kommentare