Cisco OL-4015-08 Bedienungsanleitung PDF herunterladen (Seite 325)

100

101

677

Cross-Platform Release Notes for Cisco IOS Release 12.0S

OL-1617-14 Rev. Q0

Caveats

Resolved Caveats—Cisco IOS Release 12.0(32)S

• CSCeh73978

Symptoms: When configuring service policies on any interface, the console erroneously displays a

message indicating that Rate Limit and Policing can only be configured together on 4 port ISE

Ethernet cards. More importantly, it prevents the service policy from being applied to the interface.

Conditions: This symptom has been observed on startup or anytime the configuration is entered.

Workaround: There is no workaround.

• CSCeh76209

Symptoms: When Policy Based Routing (PBR) is configured with the set interface command,

packets continue to be forwarded to an interface when that went down, causing packets to be

dropped. When the ip local policy route-map command is enabled, all locally-generated packets

are impacted.

Conditions: This symptom is observed on a Cisco router and only applies to packets that require

process-switching.

Workaround: Do not enter the set interface command. Rather, enter the set ip next-hop command.

• CSCeh78918

Symptoms: When a line card has reloaded because you reloaded the router, the line card crashed, or

you entered a command to reload the line card, the following message may appear on the console:

%MDS-2-RP: MDFS is disabled on some line card(s). Use "show ip mds stats linecard" to

view status and "clear ip mds linecard" to reset.

This message may be generated because MDFS is erroneously disabled on the reloaded line card.

Erroneous disabling of MDFS may unnecessarily extend network convergence time.

Conditions: This symptom is observed on a distributed router or switch such as a

Cisco Catalyst 6000 series, Cisco 7500 series, Cisco 7600 series, Cisco 10000 series, and

Cisco 12000 series. The symptom occurs when the router has the ip multicast-routing distributed

command enabled for any VRF and when a line card is reloaded more than 50 seconds into the

60-second MDFS flow-control period.

Workaround: The symptom corrects itself after 60 seconds. Alternatively, you can enter the clear ip

mds linecard slot number command.

• CSCeh82971

Symptoms: A Cisco router crashes when performing an FPD image upgrade operation.

Conditions: This symptom can occur if the sending of the FPD image from RP to a line card fails

because the target card is reloaded during this time window.

Workaround: Do not reload or physically remove the target upgrade line card when performing an

FPD image upgrade.

• CSCeh84320

Symptoms: The subinterface on the modular GE/FE card stops forwarding.

Conditions: This symptom occurs whenever the operator enters sub-interface mode with an

xconnect statement on the EPA-GE/FE-BBRD fixed port on the modular GE/FE card.

Workaround: While in the sub-interface mode, the operator can enter a shutdown command

followed by a no shutdown command which allows the subinterface to resume forwarding.

Each time the operator enters the sub-interface on the fixed port, the workaround will need to be

applied.

1 2 ... 320 321 322 323 324 325 326 327 328 329 330 ... 677 678

Kommentare zu diesen Handbüchern

Keine Kommentare

Cisco OL-4015-08 Bedienungsanleitung Seite 325

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Cisco OL-4015-08