Cisco OL-4015-08 Bedienungsanleitung Seite 516

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 678
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 515
868
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(31)S
AC Switching: VIP Xmit failed: DLCI 426 context missing
Conditions: This symptom is observed on a Cisco 7500 series.
Workaround: There is no workaround. To re-enable the line card, enter the tx-queue-limit command
on the affected interface of the line card.
CSCin79899
Symptoms: When error recovery is performed on a 3-port Gigabit Ethernet (GE) line card that has
port 0 in the shutdown state, the 3-port GE line card stop passing traffic on all ports.
Conditions: This symptom is observed on a Cisco 12410 that runs Cisco IOS Release 12.0(23)S or
a later release and that is configured with an Engine 2 3-port line card.
Workaround: Reload the 3-port GE line card and leave port 0 in the up/down state.
CSCin80743
Symptoms: Configurations of interfaces on a legacy interface processor such as an EIP or an FSIP
on a Cisco 7500 series go down after a redundancy-forced switchover.
Conditions: This symptom is observed on a Cisco 7500 series that runs Cisco IOS Release 12.0(28)S
or a later release or Release 12.2(25)S that is configured for SSO or RPR+.
Workaround: Manually reconfigure the interfaces.
CSCin81933
Symptoms: At a cold temperature, a Cisco 7200 series does not boot with a PA-A3-8T1IMA or
PA-A3-8E1IMA port adapter and generates a watchdog timeout error.
Conditions: This symptom is observed on a Cisco 7200 series that is configured with an NPE-300
or NPE-400 and an IMA port adapter.
Workaround: There is no workaround.
CSCin82862
Symptoms: Multicast traffic is not switched from a multilink interface on a Cisco 7500 series that
is configured for distributed multilink PPP (MLP).
Conditions: This symptom is observed when the router is reloaded or when the multilink interface
flaps.
Workaround: Enter the clear ip mds linecard * command on the Route/Switch Processor (RSP).
CSCin83445
Symptoms: Incoming multicast traffic on a distributed MLP link is process-switched.
Conditions: This symptom is observed on a Cisco 7500 series that is configured for distributed MLP
after the router has been reloaded.
Workaround: Enter the shutdown interface configuration command followed by the no shutdown
interface configuration command on the affected multilink interface.
CSCin84124
Symptoms: After performing a Fast Software Upgrade (FSU), none of the interfaces of the active
RSP come up.
Conditions: This symptom is observed on a Cisco 7500 series after you have performed a FSU to
Cisco IOS Release 12.2(25)S or Cisco IOS Release 12.0(30)S and after an SSO switchover has
occurred.
Workaround: After the FSU, enter the microcode reload command.
Seitenansicht 515
1 2 ... 511 512 513 514 515 516 517 518 519 520 521 ... 677 678

Kommentare zu diesen Handbüchern

Keine Kommentare