Cisco OL-4015-08 Bedienungsanleitung Seite 405

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 678
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 404
757
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(31)S4
Conditions: This symptom is platform- and release-independent.
Workaround: Verify the subinterface configuration upon recreation, and remove or reconfigure the
configuration as needed.
CSCei05246
Symptoms: After an OIR of a PA-MC-E3 port adaptor that is installed in a VIP6-80, the serial
interfaces do not transmit. The message “not transmitting” is generated, followed by “output
frozen.” After these messages, a Cbus Complex occurs.
Conditions: This symptom is observed on a Cisco 7500 series.
Workaround: There is no workaround.
CSCej15698
Symptoms: The output of the show ip mroute vrf vrf-name active command shows an incorrect
entry or rate for decapsulated traffic.
Conditions: This symptom is observed on a Cisco 12000 series that is configured for mVPN.
Workaround: There is no workaround.
CSCej35894
Symptoms: Tracebacks are generated when you configure the card type for a clear channel T3/E3
Engine 5 SPA.
Conditions: This symptom is observed on a Cisco 12000 series that runs Cisco IOS
Release 12.0(31)S3 or Release 12.0(32)S.
Workaround: There is no workaround.
CSCej40549
Symptoms: A primary SR-APS physical interface may flap for several minutes in a scaled
configuration with 1000 VCs that are configured while the router boots.
Conditions: This symptom is observed on a Cisco 12000 series that runs the c12kprp-p-mz image,
that is configured with a 4-port OC-3 ATM ISE line card or 4-port OC-12 ATM ISE line card, and
that has SR-APS enabled.
Workaround: There is no workaround.
CSCej57949
Symptoms: When you change the Cisco IOS software image from any release to a release later than
Release 12.0(27)S2, the redundancy mode is unexpectedly changed from SSO or RPR+ to RPR.
For example, the symptom occurs in the following situations:
From Release 12.0(26)S4 to Release 12.0(31)S
From Release 12.0(29)S to Release 12.0(31)S
From Release 12.0(31)S to Release 12.0(28)S
Conditions: This symptom is observed on a Cisco 7500 series. The symptom does not occur when
you change the Cisco IOS software image from any release to a release earlier than
Release 12.0(27)S2. For example, the symptom occurs in the following situations:
From Release 12.0(31)S1 to Release 12.0(26)S4
From Release 12.0(27)S to Release 12.0(25)S
Workaround: After you have changed the Cisco IOS release, manually change the redundancy mode
back from RPR to SSO or RPR+.
Seitenansicht 404
1 2 ... 400 401 402 403 404 405 406 407 408 409 410 ... 677 678

Kommentare zu diesen Handbüchern

Keine Kommentare