
697
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(32)S
Conditions: This symptom is observed on a Cisco 12000 series after you have configured a deny
option for an ACL.
Workaround: There is no workaround.
• CSCej36581
Symptoms: When you reload a SIP-600, the following error message is generated:
-Process= "CHOCx PRO SPA download channel-group to LC", ipl= 0, pid= 201
Conditions: This symptom is observed on a Cisco 12000 series when you reload a SIP-600 in which
two channelized OC-3 SPAs are installed (one in bay 2 and one in bay 3).
Workaround: Do not reload the SIP-600.
• CSCej40549
Symptoms: A primary SR-APS physical interface may flap for several minutes in a scaled
configuration with 1000 VCs that are configured while the router boots.
Conditions: This symptom is observed on a Cisco 12000 series that runs the c12kprp-p-mz image,
that is configured with a 4-port OC-3 ATM ISE line card or 4-port OC-12 ATM ISE line card, and
that has SR-APS enabled.
Workaround: There is no workaround.
• CSCej42144
Symptoms: A service policy on an Engine 4 + or Engine 6 line card is incorrectly rejected with the
following error message:
%E4P and E6 LC requires to configure POLICE and SET %command in every class if either
of these two commands %is configured in class-default class
This situation occurs when a set command is used in all classes.
Conditions: This symptom is observed on a Cisco 12410 that runs Cisco IOS Release 12.0(28)S3,
that is configured with dual Performance Route Processors (PRP-1s) that operate in SSO mode, and
that has multiple E4+ and/or Engine 6 line cards.
Workaround: There is no workaround.
• CSCej42935
Symptoms: Data corruption may occur on a disk when directory entries are read by more than one
process simultaneously.
Conditions: This symptom is observed on a Cisco platform that has an ATA file system when, for
example, the dir disk0: command is entered on one vty connection and simultaneously, and for the
same disk, the copy disk0: command is entered on another vty connection.
Workaround: There is no workaround.
• CSCej43126
Symptoms: When you reload a 1-port channelized OC-12 ISE line card, all traffic over the line card
may be dropped, and an error message and traceback similar to the following may be generated:
%IPCGRP-3-SYSCALL: System call for command 14 (slot7/0) : ipc_send_rpc_blocked
timed-out (Cause: timeout)
-Traceback= 1F9F20 1FA028 491DC4 49291C 492D08 2E17EC
Conditions: This symptom is observed on a Cisco 12000 series that runs an interim release for
Cisco IOS Release 12.0(32)S and that functions in a scaled configuration.
Workaround: Reload the router. If this is not an option, there is no workaround.
Kommentare zu diesen Handbüchern