
706
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(32)S
%RP-3-FABRIC_UNI: Unicast send timed out (1)
CORRUPT PACKET DUMP:
000005C000000000 0200000000000000 0000000101000000 00062AD9B40A0003
A09D008208004500 0000000000000000 0000000000000000 0000000000000000
0000000000000000 0000000000000000 0000000000000000 0000000000000000
%RPGE-6-AUTONEG_STATE: Interface GigabitEthernet1/0: Link OK -
autonegotiation complete
%RPGE-6-AUTONEG_STATE: Interface GigabitEthernet1/2: Link OK -
autonegotiation complete
%RPGE-6-AUTONEG_STATE: Interface GigabitEthernet1/1: Link OK -
autonegotiation complete
%LCGE-3-SOP_BAD_PACKET: Found corrupt pkts in tx-sop-sram. Data path was
reset.
%OSPF-5-ADJCHG: Process 1, Nbr 10.142.65.38 on GigabitEthernet1/0 from
LOADING to FULL, Loading Done
%OSPF-5-ADJCHG: Process 1, Nbr 10.142.65.44 on GigabitEthernet1/2 from
LOADING to FULL, Loading Done
• CSCsa82886
Symptoms: A router crashes when you enter the tftp-server command.
Conditions: This symptom is observed when the filename argument of the tftp-server command has
a length of more than 67 characters.
Workaround: Ensure that the length of the filename argument does not exceed 67 characters.
• CSCsa83881
Symptoms: An interface of a PA-T3+ port adapter remains up during an Unavailable Seconds (UAS)
condition that occurs because of a high C-bit or P-bit error rate.
Conditions: This symptom is observed on a Cisco 7200 series that is configured with a PA-T3+ port
adapter.
Workaround: There is no workaround.
• CSCsa84587
Symptoms: A 6PE router crashes during an IPv6 ping to another PE router at the far side of the
network.
Conditions: This symptom is observed when you enter the no mpls ipv6 source-interface command
followed by no interface type number command in which the type number argument represents the
IPv6 source interface that was configured in the mpls ipv6 source-interface command.
Workaround: When you want to disable the IPv6 source interface, first enter the no interface type
number command in which the type number argument represents the IPv6 source interface that is
configured in the mpls ipv6 source-interface command and then enter the no mpls ipv6
source-interface command.
• CSCsa86572
Symptoms: A large configuration in NVRAM on a primary or secondary RSP may become
corrupted and the router may generate relevant warning messages during the execution of a copy
system:running-config nvram: startup-config command.
When you erase NVRAM by entering the erase nvram command and then enter the copy
system:running-config nvram: startup-config command, the router may crash.
Conditions: This symptom is observed on a Cisco 7500 series but is platform-independent.
Workaround: If the configuration file is significantly large, place a copy of the configuration file on
a flash card or disk with ample space and enter the boot config slot0:startup-config command to
force the startup configuration file to be read from the flash card.
Kommentare zu diesen Handbüchern