
645
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(32)S
Conditions: This symptom is observed on a Cisco router that is configure for MFR.
Workaround: Enter the shutdown interface configuration command followed by the no shutdown
interface configuration command on each serial interface that is associated with the MFR interface.
Resolved Caveats—Cisco IOS Release 12.0(32)S
All the caveats listed in this section are resolved in Cisco IOS Release 12.0(32)S. This section describes
only severity 1, severity 2, and select severity 3 caveats.
Basic System Services
• CSCdu32036
Symptoms: When you attempt to apply an access list for SNMP by entering the snmp-server
tftp-server-list command, the access list is not applied. This situation makes it possible to copy the
configuration to and from any server, regardless of the contents of the access list.
Conditions: This symptom is observed on a Cisco platform that is configured for SNMP.
The following sample configuration causes the platform to reject configuration file transfers via
SNMP from all hosts except the TFTP server that is specified in access list 5:
snmp-server tftp-server-list 5
access-list 5 permit 10.1.1.1
snmp-server community private RW 5
snmp-server tftp-server-list 5
Workaround: Apply a more general access list to restrict traffic to and from the affected platform.
Alternate Workaround: Disable the SNMP.
• CSCea56560
Symptoms: Configuring nonexisting NTP peers repeatedly may cause a router or switch to reload
unexpectedly.
Conditions: This symptom is observed on a Cisco router and Cisco switch that are configured for
NTP.
Workaround: Do not add and delete nonexisting NTP peers in quick succession, for example by
using a cut-and-paste operation.
• CSCec75641
Symptoms: A Cisco router may reload when there are two or more Telnet or console sessions to the
router.
Conditions: This symptom is observed when the following events occurs:
–
In one session, enter the show ip as-path-access-list acl-number command. The output pauses
at the “--more--” prompt when there is more than one page output.
–
In another session, enter the no ip as-path access-list acl-number command in which the
acl-number argument is the same one as in the show ip as-path-access-list acl-number
command.
–
In the first session, type in “enter” or “space” in the first session to display the rest of the show
command output.
Workaround: Do not enter the show ip as-path-access-list acl-number command when the no ip
as-path access-list acl-number command is being configured.
Kommentare zu diesen Handbüchern