Cisco OL-4015-08 Bedienungsanleitung Seite 270

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 678
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 269
622
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(32)S3
Conditions: This symptom has been observed when an SPA-CH8TE1 card is removed from the
Cisco 12000 router in an SIP-601 jacket card.
Workaround: Reload the line card.
CSCek37693
Symptoms: The speed command cannot be configured on FE interfaces.
Conditions: This symptom has been seen on a Cisco 7500 series router with a PA- 2FE-TX in a
VIP4-80. The FE port is connected to a switch port. If the switch port is set for 10MB and the FE
interface is unable to be manually configured with the speed command, the FE interface will be in
an up/down state.
Workaround: Use the speed auto command on the switch port that connects to the FE interface on
the router. By using this workaround, you will not be able to throttle the bandwidth to 10MB as
desired. The interface will be up/up, and will pass traffic at 100MB.
CSCsc61288
Symptoms: Performing dual switchover with MDRR configured on an SPA interface shows MDRR
queues as unallocated for the show policy-map command.
Conditions: This symptom has been observed when configuring MDRR on an SPA interface (POS
or SRP) and doing a dual switchover (Main-to-standby and standby-to-Main).
Workaround: Remove the MDRR configuration from the interface and reapply. The MDRR queues
reappear.
CSCsd25480
Symptoms: ISE 10G SPA sends packets with random source MAC addresses.
Conditions: The symptom has been observed intermittently on Cisco IOS Release 12.0(31)S2 with
10G SPAs on SIP-600 LC.
Workaround: There is no workaround.
CSCsd49782
Symptoms: A VIP may reload unexpectedly when you change the encapsulation from Frame Relay
to PPP.
Conditions: This symptom is observed on a Cisco platform that has a VIP that is configured for QoS.
Workaround: There is no workaround.
CSCsd57040
Symptoms: When the controller of multichannel T3 port adaptor SPA-4XCT3 goes down for a short
duration and an alarm occurs, the port adapter does not report the type of alarm.
Conditions: This symptom has been observed on Cisco 7600 series and Cisco 12000 series routers
that are configured with a SPA-4XCT3. The port adapter should provide a history table of recent
alarm conditions along with a corresponding time stamp to allow for proper troubleshooting.
Workaround: There is no workaround.
CSCsd62921
Symptoms: An SIP601 line card crashes when shutting down an SPA-8XCHT1/E1 for RPR+
switchover.
Conditions: This symptom has been observed when shutting down an SPA-8XCHT1/E1 on bay 1/1
and performing an RPR+ switchover with traffic running.
Workaround: There is no workaround.
Seitenansicht 269
1 2 ... 265 266 267 268 269 270 271 272 273 274 275 ... 677 678

Kommentare zu diesen Handbüchern

Keine Kommentare