Cisco OL-4015-08 Bedienungsanleitung Seite 260

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 678
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 259
612
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Caveats
Resolved Caveats—Cisco IOS Release 12.0(32)S4
Workaround: There is no workaround.
CSCsd46323
Symptoms: The standby RP reboots when you perform an OIR of an active VIP that is installed in
any slot of the router.
Conditions: This symptom is observed on a Cisco 7500 series that runs Cisco IOS interim
Release 12.4(7.10) and that is configured for RPR, RPR+, or SSO. The symptom may also affect
other releases.
Workaround: There is no workaround.
CSCsd59330
Symptoms: Applying the rate-limit output command to an Engine 0 DS3 subinterface will cause
the output bytes counter to not account for traffic passing across any subinterface on the interface
that is not part of a VRF.
Conditions: This symptom has been observed when using the rate-limit output command.
Workaround: Do not use the rate-limit output command.
CSCsd64707
Symptoms: There are 3 Multilink PPP (MLPPP) and 3 Multilink Frame Relay (MLFR) at 12 links
per bundle and 11 HDLC serial interfaces on one SPA-1XCHSTM1/OC3. All MLPPP bundles are
up/down on R1 when a cable is physically removed, an SSO switchover performed, and the cable
inserted on R1. All MLPPP bundles are up/up on R2.
Conditions: This symptom has been observed when physically removing the cable, doing an SSO
switchover, and inserting the cable with traffic running.
Workaround: Enter a shutdown and no shutdown command on the MLPPP bundles and the bundles
will come up.
CSCsd65902
Symptoms: Some of the thousands of L2TPv3 sessions are not forwarding traffic. The number of
affected VCs varies but is usually within a range of 5 to 10.
Conditions: This symptom has been observed with scaled L2TPv3 configuration, with up to 8000
L2TPv3 sessions.
Workaround: Flap the Attachment Circuit (AC) port.
CSCsd67457
Symptoms: When applying a policy map as in the following example, the system rejects the
configuration.
policy-map multi-line
class class-A
police rate 20000000
conform-action transmit
exceed-action drop
! note that policing actions are configured on separate lines in this example
The following error message is displayed:
%Error: Multi-action police command not supported on interface GigabitEthernet0/0/0
Conditions: This symptom has been observed when the police statement is entered on separate lines.
Workaround: Enter the police statement on a single line rather than on separate lines. For example:
policy-map single-line
Seitenansicht 259
1 2 ... 255 256 257 258 259 260 261 262 263 264 265 ... 677 678

Kommentare zu diesen Handbüchern

Keine Kommentare