Cisco 15310-MA Anleitung zur Fehlerbehebung PDF herunterladen (Seite 350)

4-42

Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0

78-18394-01

Chapter 4 Error Messages

EID-5134 On node {0} the calculated gain is much greater than expected.

The wizard cannot operate under this condition.

Please call TAC for support.

Refer to the error message text.

EID-6001 One of the XC cards has failures or is missing. Check whether all the cross-connect cards

are installed and working.

EID-6002 One of the XC cards is locked. Unlock the cross-connect card.

EID-6003 The OSC termination could not be created.

This ring ID is already assigned.

Enter a new ID for the ring.

EID-6004 A system reset cannot be performed while a BLSR ring is

provisioned on the node.

Remove the BLSR from the node and

continue with the reset procedure.

EID-6005 The timing references could not be assigned.

- Only two DS1 or BITS interfaces can be specified.

- DS1 interfaces cannot be retimed and used as a reference.

- BITS-2 is not supported on this platform.

Refer to the error message text.

EID-6006 The timing references could not be assigned.

- An NE reference can only be used if the timing mode is LINE.

- A BITS reference can only be used if the timing mode is not

LINE.

- A Line reference can only be used if the timing mode is not

EXTERNAL.

Refer to the error message text.

EID-6008 SF BER and SD BER are not provisionable on the protect line

of a protection group.

Refer to the error message text.

WID-6009 If autoadjust GFP buffers is disabled, GFP buffers available

must be set to an appropriate value based on the distance

between the circuit endpoints.

Refer to the warning message text.

WID-6010 If auto detection of credits is disabled, credits available must be

set to a value less than or equal to the number of receive credits

on the connected FC endpoint.

Refer to the warning message text.

WID-6011 Ingress idle filtering should be turned off only when required to

operate with non-Cisco Fibre Channel/FICON-over-SONET

equipment.

Refer to the warning message text.

EID-6012 The retiming configuration could not be changed because there

are circuits on this port.

You cannot change the timing configuration

on this port unless the circuits on this port

are deleted.

EID-6013 The NTP/SNTP server could not be changed.

{1}

Refer to the error message text.

EID-6014 The operation failed because the reference state is OOS. Change the Out-of-service state to Active.

EID-6015 The distance extension cannot be disabled if the port media

type is FICON 1Gbps ISL or FICON 2Gbps ISL.

Refer to the error message text.

EID-6016 The card mode cannot be changed to Fibre Channel Line Rate

if the port media type is FICON 1Gbps ISL or FICON 2Gbps

ISL.

Refer to the error message text.

Table 4-1 Error Messages (continued)

Error/Warning

ID Error/Warning Message Description

1 2 ... 345 346 347 348 349 350 351 352 353 354 355 ... 379 380

Kommentare zu diesen Handbüchern

Keine Kommentare

Cisco 15310-MA Anleitung zur Fehlerbehebung Seite 350

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Cisco 15310-MA