Cisco 15310-MA Anleitung zur Fehlerbehebung PDF herunterladen (Seite 214)

2-84

Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0

78-18394-01

Chapter 2 Alarm Troubleshooting

Alarm Procedures

The Inhibit Switch To Protect Request on Equipment condition occurs on traffic cards when the ability

to switch to protect has been disabled. If the port is part of a 1+1 protection scheme, traffic remains

locked onto the working system.

Clear the INHSWPR Condition

Step 1 If the condition is raised against a 1+1 port, complete the “Initiate a 1+1 Manual Switch Command”

procedure on page 2-157.

Step 2 If the condition does not clear, log into the Cisco Technical Support Website at

http://www.cisco.com/techsupport for more information or call Cisco TAC (1-800-553-2447).

2.7.119 INHSWWKG

Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA) for ONS 15310-MA

SONET Logical Object: EQPT

The Inhibit Switch To Working Request on Equipment condition occurs on ONS 15310-MA traffic cards

when the ability to switch to working has been disabled. If the card is part of a 1+1 protection scheme,

traffic remains locked onto the protect system.

Step 1 If the condition is raised against a 1+1 port, complete the “Initiate a 1+1 Manual Switch Command”

procedure on page 2-157.

Step 2 If the condition does not clear, log into the Cisco Technical Support Website at

http://www.cisco.com/techsupport for more information or call Cisco TAC (1-800-553-2447).

2.7.120 INTRUSION-PSWD

Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)

SONET Logical Object: NE

The Security Intrusion Incorrect Password condition occurs after a Superuser attempts a settable number

of unsuccessful logins, a login with an expired password, or an invalid password. The alarmed user is

locked out of the system, and INTRUSION-PSWD condition is raised. This condition is only shown in

Superuser login sessions, not in login sessions for lower-level users. The INTRUSION-PSWD condition

is automatically cleared when a settable lockout timeout expires, or it can be manually cleared in CTC

by the Superuser if lockout is permanent.

Clear the INTRUSION-PSWD Condition

Step 1 In node view, click the Provisioning > Security tabs.

Step 2 Click Clear Security Intrusion Alarm.

1 2 ... 209 210 211 212 213 214 215 216 217 218 219 ... 379 380

Keine Kommentare

Cisco 15310-MA Anleitung zur Fehlerbehebung Seite 214