Cisco 15310-MA Anleitung zur Fehlerbehebung PDF herunterladen (Seite 343)

4-35

Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0

78-18394-01

Chapter 4 Error Messages

EID-5002 The tunnel could not be restored and must be recreated

manually.

Refer to the error message text.

EID-5003 The circuit roll failed.

{0}

Refer to the error message text.

EID-5004 There is already one four-fiber {0} provisioned on the set of

nodes involved in {1}. The maximum number of four-fiber {0}

rings has been reached for that node.

There is already one 4F BLSR provisioned

on the set of nodes involved in the ring. The

maximum number of 4F BLSR rings has

been reached for that node.

WID-5005 A non-zero hold-off time can violate switching time standards,

and should only be used for a circuit with multiple path

selectors.

Refer to the warning message text.

WID-5006 Warning: A different secondary {0} node should only be used

for DRI or open-ended path protected circuits.

You should use different secondary end

point only for DRI or open-ended path

protected circuits.

WID-5007 If you change the scope of this view, the contents of this profile

editor will be lost.

Refer to the warning message text.

WID-5008 Please ensure that all the protection groups are in proper states

after the cancellation.

Refer to the warning message text.

WID-5009 The circuit {0} is not upgradable.

No {1} capable {2}s are available at the node {3}.

No VT capable STSs are available at the

node.

EID-5010 The domain name already exists. Refer to the error message text.

EID-5011 The domain name cannot exceed {0} characters. You may have reached the maximum

number of characters.

WID-5012 The software load on {0} does not support the addition of a

node to a 1+1 protection group.

Refer to the warning message text.

EID-5013 {0} does not support the bridge and roll feature. Please select a

different port.

The specified port does not support Bridge

and Roll.

EID-5014 An automatic network layout is already in progress.

Please wait for it to complete before running it again.

You must for the automatic network layout

to complete before running it again.

WID-5015 {0} cannot be applied to {1}. You cannot apply the admin state operation,

specified by {0}, to port count, specified by

{1}.

EID-5016 An error occurred while attempting to provision the {0}.

{1}

CTC encountered an error while

provisioning the card.

EID-5017 Provisioning could not be rolled back. The {0} might be left in

an INCOMPLETE state and should be manually removed.

You may have to remove the BLSR

manually as it was left incomplete.

EID-5018 {0} is a(n) {1} node and cannot be added to a(n) {2} network. You cannot add the node {0} of type {1} to

the host node of type {2}. This prevents you

from hosting both SONET and SDH nodes

in the same session.

Table 4-1 Error Messages (continued)

Error/Warning

ID Error/Warning Message Description

1 2 ... 338 339 340 341 342 343 344 345 346 347 348 ... 379 380

Kommentare zu diesen Handbüchern

Keine Kommentare

Cisco 15310-MA Anleitung zur Fehlerbehebung Seite 343

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Cisco 15310-MA