Cisco 15310-MA Anleitung zur Fehlerbehebung PDF herunterladen (Seite 272)

2-142

Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0

78-18394-01

Chapter 2 Alarm Troubleshooting

Alarm Procedures

Step 4 Click Ye s in the Resetting Card dialog box.

Step 5 If the condition does not clear, log into the Technical Support Website at

http://www.cisco.com/techsupport for more information or call Cisco TAC (1-800-553-2447).

2.7.236 SWMTXMOD-PROT

Default Severity: Critical (CR), Service-Affecting (SA) for ONS 15310-MA

SONET Logical Object: EQPT

The Switching Matrix Module Failure on Protect Slot alarm is raised by the Slot 4 CTX2500 card if this

card is active (ACT). SWMTXMOD-PROT occurs when a logic component internal to the is out of frame

(OOF) with a traffic card in the system. In this case, the alarm is raised against the traffic card slot.

Clear the SWMTXMOD-PROT Alarm

Step 1 Complete the “Soft- or Hard-Reset a Controller Card” procedure on page 2-162 procedure for the Slot 4

card. For the LED behavior, see the “2.9.2 Typical Card LED Activity During Reset” section on

page 2-156.

Step 2 Verify that the reset is complete and error-free and that no new related alarms appear in CTC. A green

ACT/SBY LED indicates an active card. An amber ACT/SBY LED indicates a standby card.

Step 3 If the alarm does not clear, complete the “Remove and Reinsert (Reseat) a Card” section on page 2-163

procedure for the Slot 4 controller card.

Step 4 If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport

for more information or call Cisco TAC (1 800 553-2447) in order to report a Service-Affecting (SA)

problem.

2.7.237 SWMTXMOD-WORK

Default Severity: Critical (CR), Service-Affecting (SA)

SONET Logical Object: EQPT

The Switching Matrix Module Failure on Working Slot alarm is raised by the 15310-CL-CTX or

CTX2500 card when a logic component internal to the card’s cross connect is OOF with a traffic card in

the system. In this case, the alarm is raised against the traffic card slot.

Clear the SWMTXMOD-WORK Alarm

Step 1 Complete the “Soft- or Hard-Reset an Ethernet or Electrical Card in CTC” procedure on page 2-162 for

the controller card. For the LED behavior, see the “2.9.2 Typical Card LED Activity During Reset”

section on page 2-156.

Step 2 Verify that the reset is complete and error-free and that no new related alarms appear in CTC. A green

ACT/SBY LED indicates an active card. An amber ACT/SBY LED indicates a standby card.

1 2 ... 267 268 269 270 271 272 273 274 275 276 277 ... 379 380

Keine Kommentare

Cisco 15310-MA Anleitung zur Fehlerbehebung Seite 272