Cisco 15310-MA Anleitung zur Fehlerbehebung PDF herunterladen (Seite 177)

2-47

Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0

78-18394-01

Chapter 2 Alarm Troubleshooting

Alarm Procedures

Caution Avoid soft-resetting multiple ONS 15310-MA cards at one time; doing so might cause an unexpected

traffic hit.

For the LED behavior, see the “2.9.2 Typical Card LED Activity During Reset” section on page 2-156.

Step 8 Verify that the reset is complete and error-free and that no new related alarms appear in CTC. A green

ACT/SBY LED indicates an active card. An amber ACT/SBY LED indicates a standby card.

Step 9 If the alarm does not clear, complete the “Remove and Reinsert (Reseat) a Card” procedure on

page 2-163 procedure for the standby Ethernet card.

Step 10 Complete the “Initiate an ONS 15310-MA 1:1 Card Switch Command” procedure on page 2-159 to

switch traffic back.

Step 11 If the alarm does not clear, complete the “Physically Replace a Card” section on page 2-163 procedure

for the reporting traffic card.

Step 12 If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport

for more information or call Cisco TAC (1 800 553-2447) in order to report a Service-Affecting (SA)

problem.

2.7.48 CTNEQPT-PBWORK

Default Severity: Critical (CR), Service-Affecting (SA)

SONET Logical Object: EQPT

The Interconnection Equipment Failure Working 15310-CL-CTX or CTX2500 card Payload Bus alarm

indicates a failure in the main payload bus between the 15310-CL-CTX or CTX2500 card and the

reporting Ethernet card. The controller card and the Ethernet or electrical card are no longer

communicating.

Clear the CTNEQPT-PBWORK Alarm

Step 1 If the alarm is reported against the 15310-CL-CTX or CTX2500 card, go to Step 4. If the Ethernet or

electrical traffic card shows the CTNEEQPT-PBWORK alarm, complete the “Soft- or Hard-Reset an

Ethernet or Electrical Card in CTC” procedure on page 2-162 for the card.

Step 2 Verify that the reset is complete and error-free and that no new related alarms appear in CTC. A green

ACT LED indicates an active card.

Step 3 If the alarm does not clear, complete the “Physically Replace a Card” procedure on page 2-163.

Caution Always use the supplied electrostatic discharge wristband when working with a powered ONS 15310-CL

or ONS 15310-MA.

Note When you replace a card with the identical type of card, you do not need to make any changes

to the database.

1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 379 380

Keine Kommentare

Cisco 15310-MA Anleitung zur Fehlerbehebung Seite 177