Cisco 15310-MA Anleitung zur Fehlerbehebung PDF herunterladen (Seite 249)

2-119

Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, Release 9.0

78-18394-01

Chapter 2 Alarm Troubleshooting

Alarm Procedures

The Manufacturing Data Memory Failure alarm occurs when the electronically erasable programmable

read-only memory (EEPROM) fails on a card or component, or when the 15310-CL-CTX or CTX2500

card cannot read this memory. EEPROM stores manufacturing data that a 15310-CL-CTX card uses to

determine system compatibility and shelf inventory status. Unavailability of this information can cause

less-significant problems.

To clear the MFGMEM alarm, log into the Technical Support Website at

http://www.cisco.com/techsupport for more information or call Cisco TAC (1-800-553-2447) to report

a Service-Affecting (SA) problem.

2.7.183 NO-CONFIG

Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)

SONET Logical Object: EQPT

The No Startup Configuration condition applies to ML-100T-8 Ethernet cards and occurs when no

startup configuration file has been downloaded to the 15310-CL-CTX or CTX2500 card, whether or not

you preprovision the card slot. This alarm can occur during provisioning. When the startup configuration

file is copied to the 15310-CL-CTX or CTX2500 card, the alarm clears.

Note For more information about Ethernet cards, refer to the Cisco ONS 15310-CL and Cisco ONS 15310-MA

Ethernet Card Software Feature and Configuration Guide.

Clear the NO-CONFIG Condition

Step 1 Create a startup configuration for the card in Cisco IOS.

General ML-100T-8 provisioning parameters are located in the Cisco ONS 15310-CL and

Cisco ONS 15310-MA Ethernet Card Software Feature and Configuration Guide. The Guide also contains

information about where to find additional IOS information.

Step 2 Upload the configuration file to the controller card by completing the following steps:

a. In node view, right-click the ML-100T-8 Ethernet card graphic.

b. Choose IOS Startup Config from the shortcut menu.

c. Click Local > CTX and navigate to the file location.

Step 3 Complete the “Soft- or Hard-Reset an Ethernet or Electrical Card in CTC” procedure on page 2-162.

Step 4 If the condition does not clear, log into the Technical Support Website at

http://www.cisco.com/techsupport for more information or call Cisco TAC (1-800-553-2447).

2.7.184 NON-CISCO-PPM

Default Severity: Not Reported (NR), Non-Service-Affecting (NSA)

SONET Logical Object: PPM

The Non-Cisco PPM Inserted condition occurs when a PPM that is plugged into a card’s port fails the

security code check. The check fails when the PPM used is not a Cisco PPM.

1 2 ... 244 245 246 247 248 249 250 251 252 253 254 ... 379 380

Keine Kommentare

Cisco 15310-MA Anleitung zur Fehlerbehebung Seite 249