Cisco Explorer 4700 Installationsanleitung PDF herunterladen (Seite 416)

100

101

11-20

Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance

OL-26645-02

Chapter 11 Configuring High Availability

Tracking Hosts for High Availability

• Tracking Hosts for High Availability, page 11-20

Tracking Hosts for High Availability

Use this procedure to configure a tracking and failure detection process for a gateway or host.

Procedure

Step 1 Choose Config > Virtual Contexts > HA Tracking And Failure Detection > Hosts. The Track Host

table appears.

Step 2 Click Add to add a new tracking process to the table, or select an existing entry, and then click Edit to

modify it. The Track Host configuration screen appears.

Step 3 In the Track Object Name field, enter a unique identifier for the tracking process. Valid entries are

unquoted text strings with no spaces and a maximum of 64 alphanumeric characters.

Step 4 For the IP Address Type, select either IPv4 or IPv6 for the host address type.

Step 5 In the Track Host/IP Address field, enter the IPv4 or IPv6 address or hostname of the gateway or host

that you want the active member of the high availability group to track.

Step 6 In the Priority field, enter the priority of the probe sent by the active member. Valid entries are integers

from 0 to 255. Higher values indicate higher priorities. Assign a priority value based on the relative

importance of the host that the probe is tracking. If the probe goes down, the ACE appliance decrements

the priority of the fault-tolerant group on the active member by the value in the Priority field.

Step 7 In the Peer Host/IP Address field, enter the IPv4 or IPv6 address or hostname of the host that you want

the standby member to track.

Step 8 In the Peer Priority field, enter the priority of the probe sent by the standby member. Valid entries are

integers from 0 to 255. Higher values indicate higher priorities. Assign a priority value based on the

relative importance of the host that the probe is tracking. If the probe goes down, the ACE appliance

decrements the priority of the fault-tolerant group on the standby member by the value in the Priority

field.

Step 9 Do the following:

• Click Deploy Now to save your entries and to continue with configuring track host probes. See

Configuring Host Tracking Probes, page 11-21.

• Click Cancel to exit this procedure without saving your entries and to return to the Track Host table.

• Click Next to save your entries and to configure another tracking process.

Kommentare zu diesen Handbüchern

Keine Kommentare

Cisco Explorer 4700 Installationsanleitung Seite 416

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Digitale Videorecorder (DVR) Cisco Explorer 4700