Cisco Explorer 4700 Installationsanleitung PDF herunterladen (Seite 394)

100

101

10-34

Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance

OL-26645-02

Chapter 10 Configuring Network Access

Configuring Virtual Context Static Routes

Step 3 From the pop-up window, do one of the following:

• Click Update Details to refresh the information displayed.

• Click Close to close the pop-up window.

Related Topics

• Configuring VLAN Interface NAT Pools and Displaying NAT Utilization, page 10-32

• Configuring VLAN Interface NAT Pools, page 10-32

Configuring Virtual Context Static Routes

Admin and user context modes do not support dynamic routing, therefore you must use static routes for

any networks to which the ACE appliance is not directly connected, such as when there is a router

between a network and the ACE appliance.

Procedure

Step 1 Choose Config > Virtual Contexts > context > Network > Static Routes.

The Static Route table appears.

Step 2 To add a static route for this context, click Add.

Note You cannot modify an existing static route. To make changes to an existing static route, you must

delete the static route and then add it back.

Step 3 For the IP Address Type, select either IPv4 or IPv6 for the route.

Step 4 In the Destination Prefix field, enter the IP address based on the address type (IPv4 or IPv6) for the route.

The address you specify for the static route is the address that is in the packet before entering the ACE

appliance and performing network address translation.

Step 5 In the Destination Prefix Mask field for an IPv4 address, select the subnet to use for this route.

In the Destination Prefix-length field for an IPv6 address, enter the prefix length from 0 to 128 to use

for this route.

Step 6 (IPv6 IP Address Type only) For the Outgoing Interface Type, select one of the following:

• N/A (Not applicable)

• VLAN

• BVI

If you select VLAN or BVI, select its number from the drop down menu. To configure an interface, click

Plus. After configuring it, select its number from the drop down menu.

Step 7 In the Next Hop field, enter the IP address of the gateway router based on the address type (IPv4 or IPv6)

for this route. The gateway address must be in the same network as a VLAN interface for this context.

Step 8 Do the following:

• Click Deploy Now to save your entries and to return to the Static Route table.

1 2 ... 389 390 391 392 393 394 395 396 397 398 399 ... 647 648

Kommentare zu diesen Handbüchern

Keine Kommentare

Cisco Explorer 4700 Installationsanleitung Seite 394

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Digitale Videorecorder (DVR) Cisco Explorer 4700