Cisco Explorer 4700 Installationsanleitung PDF herunterladen (Seite 41)

3-5

Device Manager Guide, Cisco ACE 4700 Series Application Control Engine Appliance

OL-26645-02

Chapter 3 Using DM Guided Setup

Using ACE Hardware Setup

Step 6 If you are configuring an ACE appliance, to group physical ports together on the ACE appliance to form

a logical Layer 2 interface called the port-channel (sometimes known as EtherChannels), click Port

Channel Interfaces under ACE Hardware Setup.

The Port Channel Interfaces window appears (Config > Guided Setup > ACE Hardware Setup > Port

Channel Interfaces).

Note You must configure port channels on both the ACE appliance and the switch that the ACE is

connected to.

Perform the following actions to configure a port channel interface:

a. At the top of the Port Channel Interfaces table, click Add (+) to add a port channel interface, or

choose an existing port channel interface and click Edit to modify it. The New Port Channel

Interface window appears.

Note If you click Edit, not all of the fields can be modified.

b. Enter the port channel interface attributes as described in the “Configuring Port Channel Interfaces”

section on page 10-2.

c. Click Deploy Now to deploy this configuration on the ACE and save your entries to the

running-configuration and startup-configuration files.

d. To display statistics and status information for a port-channel interface, choose the interface from

the Port Channel Interfaces table and click Details. The show interface port-channel CLI

command output appears. See the “Displaying Port Channel Interface Statistics and Status

Information” section on page 10-5 for details.

Step 7 If you are configuring an ACE appliance, to configure one or more of the Gigabit Ethernet ports on the

appliance, click GigabitEthernet Interfaces under ACE Hardware Setup. The GigabitEthernet

Interfaces window appears (Config > Guided Setup > ACE Hardware Setup > GigabitEthernet

Interfaces).

a. Choose an existing Gigabit Ethernet interface and click Edit to modify it.

b. Enter the Gigabit Ethernet physical interface attributes as described in the “Configuring Gigabit

Ethernet Interfaces” section on page 10-5.

c. Click Deploy Now when completed to deploy this configuration on the ACE and save your entries

to the running-configuration and startup-configuration files.

d. Repeat Steps a through c for each Gigabit Ethernet interface that you want to configure.

e. To display statistics and status information for a particular Gigabit Ethernet interface, choose the

interface from the GigabitEthernet Interfaces table, and then click Details. The show interface

gigabitEthernet CLI command output appears. See the “Displaying Gigabit Ethernet Interface

Statistics and Status Information” section on page 10-9 for details.

Step 8 If the ACE is a member of an HA ACE pair, click VLAN Interfaces under ACE Hardware Setup.

The VLAN Interfaces window appears (Config > Guided Setup > ACE Hardware Setup > VLAN

Interfaces).

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 647 648

Keine Kommentare

Cisco Explorer 4700 Installationsanleitung Seite 41