Cisco 3631 Spezifikationen PDF herunterladen (Seite 63)

CHAPTER

3-1

Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers

OL-1957-03

Configuring with the Command-Line Interface

This chapter describes how to use the Cisco IOS software command-line interface (CLI) to configure

basic router functionality, including:

• Configuring the Host Name and Password, page 3-2

• Configuring 1-Port and 2-Port Ethernet Interfaces, page 3-3

• Configuring Fast Ethernet Interfaces, page 3-4

• Configuring Asynchronous/Synchronous Serial Network Modules or WAN Interface Cards, page

3-5

• Configuring 16-Port and 32-Port Asynchronous Network Modules, page 3-9

• Configuring ISDN BRI WAN Interface Cards, page 3-10

• Configuring T1 and E1 Interfaces, page 3-15

• Configuring T1 (FT1) WAN Interface Cards, page 3-19

• Configuring ATM Interfaces, page 3-20

• Configuring Inverse Multiplexing for ATM Interfaces, page 3-23

• Configuring Analog Modem Interfaces, page 3-26

• Configuring Wireless Multipoint Interfaces, page 3-29

• Configuring 1-Port ADSL WAN Interface Card, page 3-29

• Configuring the NM-AIC-64, Contact Closure Network Module, page 3-34

• Configuring the 1-Port HSSI Network Module, page 3-46

• Configuring the Compression Network Module for the Cisco 3600 Series Routers, page 3-49

• Configuring the Digital Modem Network Module for the Cisco 3640 Router, page 3-50

• Configuring G.SHDSL on a Cisco Router, page 3-60

• Saving Configuration Changes, page 3-65

• Where to Go Next, page 3-65

Follow the procedures in this chapter to configure the router manually, or if you want to

change the configuration after you have run the setup command facility Using the Setup Command

Facility, page 2-1.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 197 198

Keine Kommentare

Cisco 3631 Spezifikationen Seite 63