Cisco 3631 Spezifikationen PDF herunterladen (Seite 94)

3-32

Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers

OL-1957-03

Chapter 3 Configuring with the Command-Line Interface

Configuring 1-Port ADSL WAN Interface Card

Verifying ATM Configuration

Use the following commands to verify configuration:

• To verify current configuration and to view the status for all controllers, use the show

running-config command.

• To view ATM controller statistics, use the show controllers atm slot/port command.

• To verify the PVC status, use the show atm vc command. Make sure that active PVCs are up.

• To help identify ATM-related events as they are generated, use the debug atm events command.

• To indicate what interfaces are having trouble, use the debug atm errors command.

• To identify an entry for the ATM interface you configured and to show an entry for the ATM slot/port

you configured, use the show ip route command.

• To display the configured list of ATM static maps to remote hosts on an ATM network, use the show

atm map command.

Step 7

Router(config-if-vc)#

encapsulation {aal2 |

aal5ciscoppp | aal5mux |

aal5nlpid | aal5snap}

(Optional) Configure the ATM adaptation layer (AAL) and

encapsulation type.

• aal2—AAL2

• aal5ciscoppp—Cisco PPP over AAL5

• aal5mux—AAL5+MUX

• aal5nlpid—AAL5+NLPID

• aal5snap—AAL5+LLC/SNAP (the default)

Step 8

Router(config-if-vc)# exit

Exit from interface-atm-vc configuration mode.

Step 9

Router(config-if)# dsl

operating-mode {ansi-dmt |

auto | itu-dmt |

splitterless}

Configure the ADSL interface to operate in a specified

mode:

• ansi-dmt—ANSI full rate mode per T1.413 (ITU

G.DMT Issue 1)

• auto—Automatic detection mode

• itu-dmt—ITU full rate mode (ITU G.DMT Issue 1)

• splitterless—G.lite mode per ITU G.992.2

Caution This command is for testing or lab environments

only. Using a configuration other than the

default configuration for the DSL operating

mode can lead to unpredictable behavior on the

ADSL line.

Step 10

Router(config-if)# no

shutdown

Activate the ATM interface.

Step 11

Router(config-if)# exit

Exit from ATM interface configuration mode.

Step 12

Router(config)# exit

Exit from global configuration mode.

Step 13

Router# show interface atm

1/0

Verify the ATM interface configuration.

Command Purpose

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 197 198

Kommentare zu diesen Handbüchern

Keine Kommentare

Cisco 3631 Spezifikationen Seite 94

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Cisco 3631