Cisco 3631 Spezifikationen PDF herunterladen (Seite 61)

2-25

Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers

OL-1957-03

Chapter 2 Using the Setup Command Facility

Where to Go Next

Step 2 When the messages stop displaying on your screen, press Return to get the 2600> prompt.

Note If you see the next message, it means that no other AppleTalk routers were found on the

network attached to the port.

%AT-6-ONLYROUTER: Ethernet0/0: AppleTalk port enabled; no neighbors found

Step 3 The 2600> prompt indicates that you are now at the command-line interface (CLI) and you have just

completed a basic router configuration. However, this is not a complete configuration. At this point you

have two choices:

• Run the setup command facility again and create another configuration. Enter the following:

2600> enable

Password: password

2600# setup

• Modify the existing configuration or configure additional features with the CLI as described in

Chapter 3, “Configuring with the Command-Line Interface.”

Where to Go Next

At this point you can proceed to the following:

• “Chapter 3, “Configuring with the Command-Line Interface,” to learn how to use the CLI to

configure additional features.

• The Cisco IOS software configuration guide and command reference publications for more

advanced configuration topics. These publications are available on Cisco.com, the Documentation

CD-ROM that came with your router, or you can order printed copies. For more information, refer

to “Obtaining Documentation.”

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 197 198

Keine Kommentare

Cisco 3631 Spezifikationen Seite 61