Cisco 3631 Spezifikationen PDF herunterladen (Seite 53)

2-17

Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers

OL-1957-03

Chapter 2 Using the Setup Command Facility

Configuring Interface Parameters

Defining ISDN Service Profile Identifiers

Some service providers assign service profile identifiers (SPIDs) to define the services subscribed to by

an ISDN device. If your service provider requires SPIDs, your ISDN device cannot place or receive calls

until it sends a valid SPID to the service provider when initializing the connection. A SPID is usually a

seven-digit telephone number plus some optional numbers, but service providers may use different

numbering schemes. SPIDs have significance at the local access ISDN interface only; remote routers are

never sent the SPID.

Currently, only DMS-100 and NI-1 switch types require SPIDs. Two SPIDs are assigned for the

DMS-100 switch type, one for each B channel. The AT&T 5ESS switch type may support SPIDs, but

Cisco recommends that you set up that ISDN service without SPIDs.

If your service provider assigns you SPIDs, you must define these SPIDs on the router. To define SPIDs

and the local directory number (LDN) on the router for both ISDN BRI B channels, use the following

isdn spid commands:

Router(config-if)# isdn spid1 spid-number [ldn]

Router(config-if)# isdn spid2 spid-number [ldn]

Note Although the LDN is an optional parameter in the command, you may need to enter it so the router

can answer calls made to the second directory number.

5ESS National ISDN

(NI-1) BRI

Terminal type = A

2 B channels for voice and data

2 directory numbers assigned by service provider

2 SPIDs required; assigned by service provider

Set speed for ISDN calls to 56 kbps outside local exchange

Directory number 1 can hunt to directory number 2

DMS-100 BRI 2 B channels for voice and data

2 directory numbers assigned by service provider

2 SPIDs required; assigned by service provider

Functional signaling

Dynamic terminal endpoint identifier (TEI) assignment

Maximum number of keys = 64

Release key = no, or key number = no

Ringing indicator = no

EKTS = no

PVC = 2

Request delivery of calling line ID on Centrex lines

Set speed for ISDN calls to 56 kbps outside local exchange

Directory number 1 can hunt to directory number 2

Table 2-2 ISDN Provisioning by Switch Type (continued)

Switch Type Provisioning

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 197 198

Kommentare zu diesen Handbüchern

Keine Kommentare

Cisco 3631 Spezifikationen Seite 53

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Cisco 3631