Cisco 3631 Spezifikationen PDF herunterladen (Seite 72)

3-10

Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers

OL-1957-03

Chapter 3 Configuring with the Command-Line Interface

Configuring ISDN BRI WAN Interface Cards

You can configure the interfaces on your BRI WAN interface card manually by entering Cisco IOS

commands on the command line. This method, called configuration mode, provides the greatest power

and flexibility.

Command Purpose

Step 1

Router> enable

Password: password

Router#

Enter enable mode. Enter the password.

You have entered enable mode when the prompt

changes to

Router#.

Step 2

Router# configure terminal

Enter configuration commands, one per line.

End with CNTL/Z.

Router(config)#

Enter global configuration mode. You have

entered global configuration mode when the

prompt changes to

Router(config)#.

Step 3

Router# ip routing

Router# appletalk routing

Router# ipx routing

Enable routing protocols as required for your

global configuration. This example uses IP

routing, AppleTalk routing, and Internetwork

Packet Exchange (IPX) routing.

Step 4

Router(config)# interface async 45

Router(config-if)#

Enter the interface configuration mode and specify

the asynchronous interface to configure. You have

entered interface configuration mode when the

prompt changes to

Router(config-if)#.

Step 5

Router(config-if)# ip address 172.16.74.1

255.255.255.0

Assign the IP address and subnet mask to the

interface.

Step 6

Router(config-if)# appletalk static

cable-range 5-5

Router(config-if)# appletalk zone ZZAsync

Router(config-if)# ipx network B003

Configure routing protocols on the interface. You

must have previously enabled these protocols as

part of global configuration. In this example,

AppleTalk and IPX are being configured on the

interface.

Step 7

Router(config-if)# async mode dedicated

Router(config-if)# async default routing

Router(config-if)# line async 45

Router(config-if)# speed 115200

Configure asynchronous parameters according to

your needs.

Step 8

Router(config-if)# exit

Return to the global configuration mode and

repeat Step 4 through Step 7 if your router has

more than one interface that you need to

configure.

Step 9

Router(config)# Ctrl-z

Router#

Return to enable mode.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 197 198

Kommentare zu diesen Handbüchern

Keine Kommentare

Cisco 3631 Spezifikationen Seite 72

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Cisco 3631

Prodotti e manuali riguardandi Acustica Hyundai H-HAS6006