Cisco 3631 Spezifikationen PDF herunterladen (Seite 116)

3-54

Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers

OL-1957-03

Chapter 3 Configuring with the Command-Line Interface

Configuring the Digital Modem Network Module for the Cisco 3640 Router

Configure the ISDN D-Channel Serial Interface for E1 Modules

To configure the ISDN D-channel serial interface for E1 modules, perform the following tasks,

beginning in global configuration mode:

For more information about configuring E1 ISDN D-channel serial interfaces, refer to the “Configure

ISDN PRI” section in the Cisco IOS Release 11.3 Dial Solutions Configuration Guide.

Configure the ISDN D-Channel Serial Interface for T1 Modules

To configure the ISDN D-channel serial interface for T1 modules, perform the following tasks,

beginning in the global configuration mode:

Command Description

interface Serialslot/port:15

Specify the D-channel of the first PRI line and

switch to the interface configuration mode.

no ip address

Disable IP processing on this interface.

encapsulation ppp

Set the Point-to-Point Protocol (PPP) as the

encapsulation method used by this interface.

isdn incoming-voice modem

Configure all incoming voice calls to go to the

modems.

dialer rotary-group number

Create a rotary dialer group.

dialer-group number

Assign the D-channel interface(s) to the defined

rotary dialer group.

no fair-queue

Disable fair weighted queuing for this interface.

no cdp enable

Disable Cisco Discovery Protocol (CDP) on this

interface.