Cisco 3631 Spezifikationen PDF herunterladen (Seite 84)

3-22

Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers

OL-1957-03

Chapter 3 Configuring with the Command-Line Interface

Configuring ATM Interfaces

Configuring SVCs

To configure the ATM interface with switched virtual circuits (SVCs), follow this procedure:

Command Purpose

Step 1

Router> enable

Password: password

Router#

Enter enable mode. Enter the password.

You have entered enable mode when the prompt

changes to

Router#.

Step 2

Router# configure terminal

Enter configuration commands, one per line.

End with CNTL/Z.

Router(config)#

Enter global configuration mode. You have

entered global configuration mode when the

prompt changes to

Router(config)#.

Step 3

Router# ip routing

Router# appletalk routing

Router# ipx routing

Enable routing protocols as required for your

global configuration. This example uses IP

routing, AppleTalk routing, and Internetwork

Packet Exchange (IPX) routing.

Step 4

Router(config)# interface atm 1/0

Router(config-if)#

Enter interface configuration mode. You have

entered interface configuration mode when the

prompt changes to

Router(config-if)#.

Step 5

Router(config-if)# pvc 0/5 qsaal

Configure a signaling channel for the SVC.

Step 6

Router(config-if-atm-vc)# exit

Exit back to interface configuration mode.

Step 7

Router(config-if)# pvc 0/6 ilmi

Configure additional signaling channels for the

SVC.

Step 8

Router(config-if-atm-vc)# exit

Exit back to interface configuration mode.

Step 9

Router(config-if)# ip address 192.168.74.3

255.255.255.0

Assign an IP address and subnet mask to the

interface.

Step 10

Router(config-if)# appletalk static

cable-range 3-3

Router(config-if)# appletalk zone ZZEth

Router(config-if)# ipx network B005

Configure routing protocols on the interface. You

must have previously enabled these protocols as

part of global configuration. In this example,

AppleTalk and IPX are being configured on the

interface.

Step 11

Router(config-if)# svc nsap

BC.CDEF.01.234567.890A.BCDE.F012.3456.7890.

1234.12

Configure the signaling PVC and the ATM

network service access point (NSAP) address. The

signaling PVC command has the format svc

[name] nasp <20-byte address>. You have

entered interface-ATM-VC configuration mode

when the prompt changes to

Router(config-if-atm-vc).

Step 12

Router(config-if-atm-vc)# protocol ip

200.200.200.2 broadcast

Map the PVC to an address.

Step 13

Router(config-if-atm-vc)# exit

Exit back to global configuration mode.

Repeat Step 4 through Step 12 if your router has

more than one interface that you need to

configure.

Step 14

Router(config)# Ctrl-z

When you finish configuring interfaces, return to

enable mode.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 197 198

Kommentare zu diesen Handbüchern

Keine Kommentare

Cisco 3631 Spezifikationen Seite 84

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Cisco 3631