Cisco GoQAM Technical Information PDF herunterladen (Seite 91)

reset

4025561 Rev

reset

Syntax

reset

Description

The reset command is used to set all controls and alarms in a specified module to

their factory defaults.

Because this action has potentially severe consequences, this command can only be

executed by an Admin user as explained in User Authorization (on page

9), and

then only for a specific chassis and module. It is not possible to reset a range of

modules, a chassis, or a range of chassis using a single reset command. When you

enter a reset command, a dialog is presented for confirmation. You must confirm

your intention by typing yes (typing Y alone is not sufficient).

Note: In the factory default state, all pre-amplifier and post-amplifier modules have

their outputs disabled. Thus, resetting these modules results in loss of output signal.

Parameters

None

Access Rights Required

Admin

Example

*/* MODULE> modid 0105

01/05 MODULE> reset

The module control & alarm settings are about to be reset to factory defaults.

Module outputs may become disabled as a result. Are you sure you want to

proceed (Yes/No)? yes

The module has been reset to factory defaults. Please allow several

minutes for module rediscovery by the ICIM2 and then re-enable module

outputs as desired.

SUCCESS!

01/05 MODULE>

Related Commands

set control

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 307 308

Keine Kommentare

Cisco GoQAM Technical Information Seite 91