Cisco GoQAM Technical Information PDF herunterladen (Seite 86)

Cha

4 Module Mode Commands

62 4025561

Rev

Use Exit to leave Module mode, or Logout to exit the CLI interface

All keywords and parameters are caseless. That is, MoDuLe == MODULE == module

Module Commands:

alarm [parameters]

Use the 'alarm' command to show all the current alarms. This command

works in all modes. Using the optional parameter 'domain' is the same

as not using any parameter. However, using the optional parameter

'module' will display only the alarms for the currently selected module.

chassis <chassis_range> [slot [slot_range]]

Use the 'chassis' command to specify the desired chassis number.

The <chassis_range> parameter can be either a specific chassis number

between 0 and 99, or it can be '*' to indicate the wildcard chassis

selection, or it can be a range of chassis numbers. Specify a range of

chassis in the form '[DIGITS - DIGITS]' such as '[5 - 15]'.

The 'chassis' command can be optionally followed by the slot command

on the same input line.

exit

Use the 'exit' command to return to CLI mode. This command must be

used before entering ICIM or TERMINAL mode.

info <parameter> <subparameters>

Use the 'info' command to display one or more module parameter values.

Any number of available parameters can be requested with the same command.

The <parameter> field can be either alarm, control, monitor or module.

Each has a different set of <subparameters>. Following are examples:

X/Y MODULE> info alarm <name> <alarm_param>

where <name> is the actual alarm name such as Enable. Wildcards are

allowed. For example, LasTemp* will select LasTempA and LasTempB. The

following values are allowed for alarm_param:

hysteresis - The alarm threshold hysteresis value

index - The alarm number, starting at 1, in the list of

alarms

label - The name of the alarm

limitadjust - Specifies whether the alarm has adjustable

threshold values

majorhigh - The high critical alarm threshold value; must be

less than or equal to the upper limit for this

alarm

majorlow - The low critical alarm threshold value; must be

greater than or equal to the lower limit for this

alarm

minorhigh - The high non-critical alarm threshold value

minorlow - The low non-critical alarm threshold value

nominal - The alarm nominal value

rangehi - The upper limit for this alarm threshold

rangelo - The lower limit for this alarm threshold

type - The alarm type (1, 2 & 7 are adjustable)

value - The current alarm state

X/Y MODULE> info control <name> <control_param>

where <name> is the actual control name such as Enable. Wildcards are

allowed. For example, Service* will select ServiceA and ServiceB. The

following values are allowed for control_param:

index - The control number, starting at 1, in the list of

controls

label - The name of the control

rangehi - The upper limit for this control

rangelo - The lower limit for this control

rangestep - The smallest increment allowed for the control

statenames - The list of symbolic control values

type - The control type: D(igital), F(loat), B(oolean),

S(tate)

units - The units for the control

value - The current control setting

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 307 308

Kommentare zu diesen Handbüchern

Keine Kommentare

Cisco GoQAM Technical Information Seite 86

Kommentare zu diesen Handbüchern