Cisco ISE - Line Card ISE Bedienungsanleitung PDF herunterladen (Seite 41)

Cisco IOSSoftware Configurationforthe Cisco12000Series One-PortChannelized OC-12/STM-4(DS1/E1)ISE Line

How to Configure Layer 2 Features

Cisco IOS Release 12.0(27)S1

Step 1 Enter multilink interface configuration mode:

Router# configure terminal

Router(config)# interface multilink

group-number

Step 2 Assign an IP address to the multilink interface:

Router(config-if)# ip address

address mask

Router(config-if)#

Step 3 Enable PPP encapsulation:

Router(config-if)# encapsulation ppp

Router(config-if)#

Step 4 Enable Multilink PPP:

Router(config-if)# ppp multilink

Router(config-if)#

Step 5 Assign the multilink interface to a multilink bundle:

Router(config-if)# multilink-group

group-number

Router(config-if)#

Step 6 Optional. Enable Challenge Handshake Authentication Protocol (CHAP) authentication:

Router(config-if)# ppp chap hostname group

group-number

Router(config-if)#

Note If more than one bundle is configured on the Cisco 12000 series Internet Router,

you must add the ppp chap hostname group command to both the bundle and link

configurations.

Assign a Serial Interface to a Multilink Bundle

To assign a serial interface to a multilink bundle, use the following commands in interface configuration

mode:

Step 1 Select the serial interface using the form of the interface serial command that is appropriate to your

configuration context (see Table 10):

Router(config)# interface serial

slot

port

number

Step 2 Remove any specified IP address.

Router(config-if)# no ip address

Router(config-if)#

Step 3 Set the frequency of keepalive packets.

Router(config-if)# keepalive

Router(config-if)#

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 57 58

Kommentare zu diesen Handbüchern

Keine Kommentare

Cisco ISE - Line Card ISE Bedienungsanleitung Seite 41

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Cisco ISE - Line Card ISE