Cisco ASR 1001 Installationsanleitung PDF herunterladen (Seite 18)

11-334

Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide

OL-13208-11

Chapter 11 Cisco ASR 1001 Router Overview and Installation

Guidelines for an Equipment Shelf or Tabletop Installation

The chassis should already be in the area where you will install it. If you have not determined where to

install your chassis, see the “Cisco ASR 1000 Series Routers Component Overview” section on page 2-1

for information about site considerations.

If you are not rack-mounting your Cisco ASR 1000 series chassis, place it on a sturdy equipment shelf

or tabletop.

When installing the Cisco ASR 1001 Router on an equipment shelf or tabletop, ensure that the surface

is clean and that you have considered the following:

• The Cisco ASR 1001 Router requires at least 3 inches (7.62 cm) of clearance at the inlet and exhaust

vents (the front and top/rear sides of the chassis).

• The Cisco ASR 1001 Router should be installed off the floor. Dust that accumulates on the floor is

drawn into the interior of the router by the cooling fans. Excessive dust inside the router can cause

overtemperature conditions and component failures.

• There must be approximately 19 inches (48.3 cm) of clearance at the front and rear of the chassis to

install and replace FRUs, or to access network cables and equipment.

• The Cisco ASR 1001 Router needs adequate ventilation. Do not install it in an enclosed cabinet

where ventilation is inadequate.

• Keep the cable-management bracket ready if you plan to install it on the front of the chassis.

• An adequate chassis ground (earth) connection exists for your router chassis (see the “Attaching a

Chassis Ground Connection” section on page 11-343).

• Always follow proper lifting practices as outlined in the “Electrical Safety” section on page 5-21,

when handling the chassis.

Mounting the Cisco ASR 1001 Router on an Equipment Shelf or

Tabletop Installation

To mount your Cisco ASR 1001 Router on an equipment shelf or tabletop, follow these steps.

Step 1 Remove any debris and dust from the tabletop or platform, as well as the surrounding area.

Step 2 Lift the chassis into position on the equipment shelf or tabletop.

Warning

At least two people are required to lift the chassis onto a tabletop or platform. To prevent injury, keep

your back straight and lift with your legs, not your back.

Statement 164

Width 17.25 in. (43.815 cm) - 19 inch rack-mount

Weight 40 lb (18.143 k) - fully configured

Table 11-7 Cisco ASR 1001 Router Dimensions and Weight

Cisco ASR 1001 Dimensions

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 43 44

Keine Kommentare

Cisco ASR 1001 Installationsanleitung Seite 18