Cisco MC3810 Installationsanleitung PDF herunterladen (Seite 66)

show call active voice

Release 12.0(7)XK

Related Commands

NoiseLevel Active noise level for the call.

OnTimeRvPlayout Duration of voice playout from data received on time for this call. You can derive

the Total Voice Playout Duration for Active Voice by adding the

OnTimeRvPlayout value to the GapFill values.

OutSignalLevel Active output signal level to telephony interface used by this call.

PeerAddress Destination pattern associated with this peer.

PeerId ID value of the peer table entry to which this call was made.

PeerIfIndex Voice port index number for this peer.

PeerSubaddress Subaddress to which this call is connected.

ReceiveBytes Number of bytes received by the peer during this call.

ReceiveDelay Average Playout FIFO Delay plus the decoder delay during the voice call.

ReceivePackets Number of packets received by this peer during this call.

RemoteIPAddress Remote system IP address for the VoIP call.

RemoteUDPPort Remote system UDP listener port to which voice packets are transmitted.

RoundTripDelay Voice packet round trip delay between the local and remote system on the IP

backbone during the call.

SelectedQoS Selected quality of service (QoS) for the call.

SessionProtocol Session protocol used for an Internet call between the local and remote router via

the IP backbone.

SessionTarget Session target of the peer used for the call.

SetupTime Value of the System UpTime when the call associated with this entry was started.

TransmitBytes Number of bytes transmitted from this peer during the call.

TransmitPackets Number of packets transmitted from this peer during the call.

TxDuration Duration of transmit path open from this peer to the voice gateway for the call.

VADEnable Whether or not voice activation detection (VAD) was enabled for this call.

VoiceTxDuration Duration of voice transmission from this peer to voice gateway for this call. You

can derive the Voice Utilization Rate by dividing the VoiceTxDuration value by the

TxDuration value.

Command Description

show call history voice Displays the call history table.

show dial-peer voice Displays conﬁguration information for dial peers.

show num-exp Displays the number expansions conﬁgured.

show voice port Displays conﬁguration information about a speciﬁc voice port.

Table 2 Show Call Active Voice Field Descriptions (continued)

Field Description

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 77 78

Keine Kommentare

Cisco MC3810 Installationsanleitung Seite 66