Cisco MC3810 Installationsanleitung PDF herunterladen (Seite 49)

ds0-group

Configuring Voice over IP for Cisco MC3810 Series Concentrators 49

Default

No DS0 group is deﬁned.

Command Mode

Controller conﬁguration

Command History

Usage Guidelines

The ds0-group command automatically creates a logical voice port that is numbered as follows:

Cisco 2600 and 3600 series:

slot/port:ds0-group-no.

Cisco MC3810:

slot:ds0-group-no

The following options are available only on E1 controllers on the

Cisco MC3810:

• e&m-melcas-immed—E&M Mercury Exchange Limited Channel

Associated Signaling (MELCAS) immediate start signaling support

• e&m-melcas-wink—E&M MELCAS wink start signaling support

• e&m-melcas-delay—E&M MELCAS delay start signaling support

• fxo-melcas—MELCAS Foreign Exchange Ofﬁce signaling support

• fxs-melcas—MELCAS Foreign Exchange Station signaling support

The following options are available only when the mode ccs command is

enabled on the Cisco MC3810 for transparent CCS support:

• ext-sig-master—For the speciﬁed channel(s), automatically generates the

off-hook signal and stays in the off-hook state.

• ext-sig-slave—For the speciﬁed channel(s), automatically generates the

answer signal when a call is terminated to that channel.

Release Modiﬁcation

11.2 This command was introduced for the Cisco AS5300 as cas-group.

12.0(1)T The cas-group command was ﬁrst supported on the Cisco 3600

series.

12.0(5)T This command was renamed ds0-group on the Cisco AS5300 and on

the Cisco 2600 and 3600 series (requires Digital T1 Packet Voice

Trunk Network Modules).

12.0(7)XK Support for this command was extended to the Cisco MC3810. When

the ds0-group command became available on the Cisco MC3810, the

voice-group command was removed and is no longer supported.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 77 78

Keine Kommentare

Cisco MC3810 Installationsanleitung Seite 49