Cisco Cisco Access Registrar 4.2 Spezifikationen PDF herunterladen (Seite 369)

100

101

7-59

Cisco Wireless LAN Controller Configuration Guide

OL-13826-01

Chapter 7 Controlling Lightweight Access Points

Configuring Country Codes

c. Click Apply to commit your changes.

d. Click Wireless > 802.11b/g/n > Network.

e. Uncheck the 802.11b/g Network Status check box.

f. Click Apply to commit your changes.

Step 2 Click Wireless > Country to open the Country page (see Figure 7-28).

Figure 7-28 Country Page

Step 3

Check the check box for each country where your access points are installed.

Step 4 If you checked more than one check box in Step 3, a message appears indicating that RRM channels and

power levels are limited to common channels and power levels. Click OK to continue or Cancel to

cancel the operation.

Step 5 Click Apply to commit your changes.

Step 6 If you selected multiple country codes in Step 3, each access point is assigned to a country. Follow these

steps to see the default country chosen for each access point and to choose a different country if

necessary.

Note If you ever remove a country code from the configuration, any access points currently assigned

to the deleted country reboot and when they rejoin the controller, they get re-assigned to one of

the remaining countries if possible.

a. Perform one of the following:

–

Leave the 802.11a and 802.11b/g networks disabled.

–

Re-enable the 802.11a and 802.11b/g networks and then disable only the access points for

which you are configuring a country code. To disable an access point, click Wireless > Access

Points > All APs, click the link of the desired access point, choose Disable from the Admin

Status drop-down box, and click Apply.

1 2 ... 364 365 366 367 368 369 370 371 372 373 374 ... 635 636

Kommentare zu diesen Handbüchern

Keine Kommentare

Cisco Cisco Access Registrar 4.2 Spezifikationen Seite 369

Kommentare zu diesen Handbüchern