Cisco Cisco Access Registrar 4.2 Spezifikationen Seite 127

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 636
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 126
4-29
Cisco Wireless LAN Controller Configuration Guide
OL-13826-01
Chapter 4 Configuring Controller SettingsWireless Device Access
Configuring 802.3 Bridging
Using the CLI to View Message Logs
Use these commands to view system message logs through the CLI.
1. To view the current syslog status, enter this command:
show syslog
2. To view the message logs, enter this command:
show msglog
Configuring 802.3 Bridging
The controller supports 802.3 frames and the applications that use them, such as those typically used for
cash registers and cash register servers. However, to make these applications work with the controller,
the 802.3 frames must be bridged on the controller.
Support for raw 802.3 frames allows the controller to bridge non-IP frames for applications not running
over IP. Only this raw 802.3 frame format is currently supported:
+-------------------+---------------------+-----------------+------------------------+
| Destination | Source | Total packet | Payload .....
| MAC address | MAC address | length |
+-------------------+----------------------+-----------------+------------------------
You can configure 802.3 bridging through the controller GUI in software release 4.1 or later and through
the controller CLI in software release 4.0 or later.
Note You can also configure 802.3 bridging using the Cisco Wireless Control System (WCS). Refer to the
Cisco Wireless Control System Configuration Guide for instructions.
Using the GUI to Configure 802.3 Bridging
Follow these steps to configure 802.3 bridging using the controller GUI.
Step 1 Click Controller > General to open the General page (see Figure 4-9).
Seitenansicht 126
1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 635 636

Kommentare zu diesen Handbüchern

Keine Kommentare