Cisco PIX 525 Spezifikationen PDF herunterladen (Seite 94)

100

101

8-12

Cisco Security Appliance Command Line Configuration Guide

OL-6721-01

Chapter 8 Configuring IP Routing and DHCP Services

Configuring OSPF

Configuring Route Summarization Between OSPF Areas

Route summarization is the consolidation of advertised addresses. This feature causes a single summary

route to be advertised to other areas by an area boundary router. In OSPF, an area boundary router

advertises networks in one area into another area. If the network numbers in an area are assigned in a

way such that they are contiguous, you can configure the area boundary router to advertise a summary

route that covers all the individual networks within the area that fall into the specified range.

To define an address range for route summarization, perform the following steps:

Step 1 If you have not already done so, enter the router configuration mode for the OSPF process you want to

configure by entering the following command:

hostname(config)# router ospf

process_id

Step 2 To set the address range, enter the following command:

hostname(config-router)# area

area-id

range

ip-address mask

[advertise | not-advertise]

The following example shows how to configure route summarization between OSPF areas:

hostname(config)# router ospf 1

hostname(config-router)# area 17 range 12.1.0.0 255.255.0.0

Configuring Route Summarization When Redistributing Routes into OSPF

When routes from other protocols are redistributed into OSPF, each route is advertised individually in

an external LSA. However, you can configure the security appliance to advertise a single route for all

the redistributed routes that are covered by a specified network address and mask. This configuration

decreases the size of the OSPF link-state database.

To configure the software advertisement on one summary route for all redistributed routes covered by a

network address and mask, perform the following steps:

Step 1 If you have not already done so, enter the router configuration mode for the OSPF process you want to

configure by entering the following command:

hostname(config)# router ospf

process_id

Step 2 To set the summary address, enter the following command:

hostname(config-router)# summary-address

ip_address mask

[not-advertise] [tag

tag

]

OSPF does not support summary-address 0.0.0.0 0.0.0.0.

The following example shows how to configure route summarization. The summary address 10.1.0.0

includes address 10.1.1.0, 10.1.2.0, 10.1.3.0, and so on. Only the address 10.1.0.0 is advertised in an

external link-state advertisement:

hostname(config)# router ospf 1

hostname(config-router)# summary-address 10.1.0.0 255.255.0.0

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 603 604

Kommentare zu diesen Handbüchern

Keine Kommentare

Cisco PIX 525 Spezifikationen Seite 94

Kommentare zu diesen Handbüchern