Configuration Tasks
2
Release 11.1 CA
Configuration Tasks
Perform the tasks in the following sections to configure the PA-T3 (all tasks are optional except for
the first task):
• Configure the PA-T3 Port Adapter
• Troubleshoot the PA-T3 Port Adapter
• Monitor and Maintain the PA-T3 Port Adapter
For PA-T3 port adapter configuration examples, see the “Configuration Example” section, later in
this chapter.
The PA-T3 supports most interface commands. For information about these commands, refer to the
“Configuring Interfaces” chapter of the Configuration Fundamentals Configuration Guide. For
additional information on how to configure the PA-T3 serial port adapter, refer to the “Configure a
Synchronous Serial Interface” section in the “Configuring Interfaces” chapter of the Configuration
Fundamentals Configuration Guide.
For information on other commands that can be used by the PA-T3 serial port adapter, refer to the
Cisco IOS Release 11.1 configuration guides.
Configure the PA-T3 Port Adapter
In addition to the commands in the “Configure a Synchronous Serial Interface” section in the
“Configuring Interfaces” chapter of the Configuration Fundamentals Configuration Guide, the
commands listed in Table 1 have been added to support the PA-T3 interface configuration. If you do
not modify the configuration of the PA-T3, the configuration defaults shown in Table 1 are used.
If you need to change any of the default configuration attributes, complete the first task in global
configuration mode followed by any of the optional tasks in interface configuration mode:
Table 1 PA-T3 Port Adapter Defaults
Command Default Value
cablelength 50
clock source line
crc 32 16-bit
dsu bandwidth 44736 kbps
dsu mode 0
framing C-bit
invert data data is not inverted
scramble disabled
Task Command
Select the PA-T3 interface and enter interface
configuration mode.
interface serial slot/port-adapter/port (Cisco 7500
series and Cisco 7000 series routers with the
RSP7000 and RSP7000CI)
interface serial slot/port (Cisco 7200 series)
Change the cable length. cablelength length
Enable 32-bit CRC. crc 32
Change the DSU bandwidth. dsu bandwidth kbps
(64 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern