Cisco ATA-186 Betriebsanweisung PDF herunterladen (Seite 9)

Cisco ATA 186 Configuration Guide

Select the method you would like to use to configure your ATA 186 and refer

to the corresponding directions below.

Automatic Configuration via Web Configuration Page

(Recommended Method)

Using this automatic method, you can configure the device via a Web

interface: the Web Configuration page. This method automatically sets the

device to use Net2Phone and downloads the correct firmware.

1. Access the Web Configuration page by opening a Web browser and

entering the following address:

http://xxx.xxx.xxx.xxx/dev.

(“xxx.xxx.xxx.xxx” represents the IP address of your ATA 186).

The Cisco ATA 186 Web Configuration page displays (see below).

2. In the TftpURL field, enter ata186.net2phone.com.

3. If your Web Configuration Page has the field ToConfig field, enter 1.

4. In the UseTftp field, enter 1.

5. If your Web Configuration Page has the field UseMGCP, enter 1.

6. Click the Apply button at the bottom of the page.

The page will display the message ““Cisco ATA 186 Configured

Successfully, Restarting ATA Now, [Click here to reload].”

Important: After you click the apply button, do not click the reload

link! Wait at least 5 minutes. During this time, the device will be

updated with the latest firmware and the proper settings for use with

Net2Phone. You may see the light/button on top of the ATA blinking

slowly and then very fast.

7. After waiting at least five minutes, click the “[Click here to reload]”

link.

The Web Configuration Page will reload.

8. Continue with the next section, Verifying the Success of the

Automatic Configuration via the Web Configuration Page.

VERIFYING THE SUCCESS OF THE AUTOMATIC CONFIGURATION VIA THE WEB

CONFIGURATION PAGE

To verify that the automatic configuration was successful:

1. Access the Web Configuration page by opening a Web browser and

entering the following address:

http://xxx.xxx.xxx.xxx/dev.

(“xxx.xxx.xxx.xxx” represents the IP address of your ATA 186).

2. Check the lower left-hand corner of the Web Configuration page and

make sure it displays version 3.1.0.

3. Check the GkOrProxy field on the Web Configuration page and make

sure it reads sip.net2phone.com.

If the configuration was unsuccessful, power off the ATA 186 and then power

it back on again. Then wait five minutes and reload the Web Configuration

Page. If this is still unsuccessful, repeat the automatic configuration via Web

Page 6

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 22 23

Kommentare zu diesen Handbüchern

Keine Kommentare

Cisco ATA-186 Betriebsanweisung Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Cisco ATA-186