Cisco ATA-186 Betriebsanweisung PDF herunterladen (Seite 10)

Cisco ATA 186 Configuration Guide

Configuration page procedure or use the manual configuration method on

page 12.

ENTERING ACCOUNT NUMBER AND PIN

1. Port 1 Account - In the LoginID0 field, enter the account number.

2. Port 1 PIN - In the PWD0 field, enter the PIN for port 1.

3. Port 2 Account - In the LoginID1 field, enter the account number.

IMPORTANT: Unless you have a multi-user account, the

Net2Phone account number that you enter for port 2 must

be different from the account entered for port 1.

4. Port 2 PIN - In the PWD1 field, enter the PIN for port 2.

5. Click the Apply button at the bottom of the Web page to save the

changes.

Wait about 30 seconds before clicking the “[Click here to reload]” link.

When the page reloads, your account settings will be active.

Congratulations! You are now ready to make calls with your ATA.

You can now set up the ATA 186 to allow you to place calls as you usually do

in your country (without having to dial as if you were in the US). To

configure this feature, proceed to the Configuring Local Dialing section

later in this chapter.

IMPORTANT: In order to make changes to the ATA186 after

using the automatic configuration method (either IVR or

Web), you must change the following field to the following

value:

 UseTFTP: 0

Click the Apply button to save the setting. You can now

make any other changes to the device, including the local

dialing configuration.

Automatic Configuration via IVR

This automatic method relies on the telephone keypad for configuring the

parameters on the ATA 186. If you prefer to enter the values via the Web

interface, please refer to the Automatic Configuration via Web

Configuration Page section above.

ENTERING PARAMETERS

To enter parameters via the IVR:

1. Pick up the telephone handset, and press the button on top of the ATA

186.

You will hear a voice prompt that says, “Configuration Menu. Enter

menu number followed by the # key…”

Page 7

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 22 23

Keine Kommentare

Cisco ATA-186 Betriebsanweisung Seite 10