Cisco ATA-186 Betriebsanweisung PDF herunterladen (Seite 12)

Cisco ATA 186 Configuration Guide

• To enter the “o,” press the 6 key four times, followed by the

pound (#) key.

• To enter the “n,” press the 6 key three times, followed by the

pound (#) key.

• To enter the “e,” press the 3 key three times, followed by the

pound (#) key.

• To enter the dot, press the 1 key twice, followed by the pound

(#) key.

• To enter the “c,” press the 2 key four times, followed by the

pound (#) key.

• To enter the “o,” press the 6 key four times, followed by the

pound (#) key.

• To enter the “m,” press the 6 key twice, followed by the pound

(#) key.

• Press # to signal the end of the entry.

You will hear a voice prompt that says, ”You entered

‘ata186.net2phone.com.’ To change, press 1; to review, press

2; to save, press 3; to review your saved value, press 4; or

press the pound key (#) to exit.”

4. Save the setting by pressing 3 on the telephone keypad.

You will hear a voice prompt that says, ”Value saved. Configuration

Menu…”

5. Access the USE TFTP menu by pressing 305# on the telephone keypad.

You will hear a voice prompt that says, “Enter value.”

6. Enable USE TFTP by pressing 1# on the telephone keypad.

You will hear a voice prompt that says, ”You entered ‘1.’ To change,

press 1; to review, press 2; to save, press 3; to review your saved

value, press 4; or press the pound key (#) to exit.”

7. Save the setting by pressing 3 on the telephone keypad.

You will hear a voice prompt that says, ”Value saved. Configuration

Menu…”

8. Access the UseMGCP menu by pressing 38# on the telephone keypad.

You will hear a voice prompt that says, “Enter value.”

Important: Some ATAs may say, “invalid entry.” In this case,

proceed to step 11.

9. Enable UseMGCP by pressing 1# on the telephone keypad.

You will hear a voice prompt that says, ”You entered ‘1.’ To change,

press 1; to review, press 2; to save, press 3; to review your saved

value, press 4; or press the pound key (#) to exit.”

10. Save the setting by pressing 3 on the telephone keypad.

You will hear a voice prompt that says, ”Value saved. Configuration

Menu…”

11. Access the TO CONFIG menu by pressing 80001# on the telephone

keypad.

You will hear a voice prompt that says, “Enter value.”

Page 9

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 22 23

Kommentare zu diesen Handbüchern

Keine Kommentare

Cisco ATA-186 Betriebsanweisung Seite 12

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Cisco ATA-186