Cisco ATA-186 Betriebsanweisung PDF herunterladen (Seite 6)

Cisco ATA 186 Configuration Guide

7. Obtain the IP address by pressing 80# on the telephone keypad.

The system will immediately announce the IP address of your ATA

186. Please write it down.

TIP: After announcing the IP address, the system will

return to the configuration menu, so if you missed all or

part of the address, press 80# again and listen for the IP

address.

NOTE: If the IP address you hear is 0.0.0.0, then either your

network does not have a DHCP server (in which case you

should proceed to the Static IP Configuration below) or

your DHCP server is not assigning an IP address to the ATA

186 (in which case you should contact your network

administrator for assistance).

8. Hang up the telephone handset, and proceed to the Configuring

Account and Network Settings section to configure your ATA 186

for use with the Net2Phone network.

Static IP Configuration

To assign a static IP address to the ATA 186, please follow the steps below:

1. Obtain the following information from your Internet Service Provider

(ISP) or IT Administrator:

• IP Address

• Default Gateway

• Subnet Mask

• Primary DNS Server

• Secondary DNS Server (optional)

2. Pick up the telephone handset, and press the button on top of the ATA

186.

You will hear a voice prompt that says, “Configuration Menu. Enter

menu number followed by the # key…”

3. Access the DHCP menu by pressing 20# on the telephone keypad.

You will hear a voice prompt that says, “Enter value.”

4. Disable DHCP by pressing 0# on the telephone keypad.

You will hear a voice prompt that says, ”You entered ‘0.’ To change,

press 1; to review, press 2; to save, press 3; to review your saved

value, press 4; or press the pound key (#) to exit.”

5. Save the setting by pressing 3.

You will hear a voice prompt that says, ”Value saved. Configuration

Menu…”

6. Access the IP address menu by pressing 1# on the telephone keypad.

You will hear a voice prompt that says, “Enter value.”

Page 3

1 2 3 4 5 6 7 8 9 10 11 ... 22 23

Keine Kommentare

Cisco ATA-186 Betriebsanweisung Seite 6