Cisco 678 Spezifikationen PDF herunterladen (Seite 70)

Chapter 3 Configuration Procedures for the Cisco 627

Update the CBOS Prompt

3-18

Cisco 600 Series Installation and Operation Guide

78-11190-01

Interleaved Symbols with CRC Errors: 2

No Cell Delineation Interleaved: 0

Out of Cell Delineation Interleaved: 0

Header Error Check Counter Interleaved:0

Count of Severely Errored Frames: 0

Count of Loss of Signal Frames: 0

Remote Counters:

Interleaved RS Corrected Bytes: 0

Interleaved Symbols with CRC Errors: 0

No Cell Delineation Interleaved: 0

Header Error Check Counter Interleaved:0

Count of Severely Errored Frames: 0

Count of Loss of Signal Frames: 0

Update the CBOS Prompt

The default Cisco 627 system prompt is

cbos#

. The command prompt is limited

to 8 characters. You can change this prompt to a unique subscriber identifier as

shown in the following example.

Step 1

Log on to the CBOS using either the serial or Telnet interfaces. Refer to the

“

Using Telnet” section on page 3-6 for more information on how to use Telnet to

log on to the CBOS.

Step 2

To change the default prompt to 4412883 as the subscriber identifier, enter:

cbos# set prompt 4412883

4412883#

Step 3

To save your changes, enter:

4412883# write

Step 4

To exit the CBOS, enter:

4412883# quit

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 191 192

Keine Kommentare

Cisco 678 Spezifikationen Seite 70