Cisco 678 Spezifikationen PDF herunterladen (Seite 115)

5-31

Cisco 600 Series Installation and Operation Guide

78-11190-01

Chapter 5 Configuration Procedures for the Cisco 67x CPE Devices

Configure Line Coding (Cisco 677 and Cisco 678 only)

Step 3

To verify these values, enter:

show timeout

Step 4

To save your changes, enter:

write

Step 5

To exit CBOS, enter:

quit

Configure Line Coding (Cisco 677 and Cisco 678 only)

The Cisco 677 and Cisco 678 allow you to choose transmission protocols to match

your network configuration by changing the router’s configuration file. Use TFTP

to transfer files to and from a CPE. This section describes procedures to configure

the CPE for Discrete Multi-Tone (DMT), Carrierless Amplitude and Phase

Modulation (CAP), G.Lite, or G.DMT protocols.

Note

Changes to your CPE must be coordinated with the central office

equipment. Not all protocols described here are available on all CPE

models.

Configure for CAP

Step 1

Verify the connection from the router to the location where the correct software

image is stored. This location is provided by your network administrator.

Typically, you use the

ping

command for this step.

Step 2

Enable TFTP:

cbos#set tftp enabled

TFTP is enabled

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 191 192

Keine Kommentare

Cisco 678 Spezifikationen Seite 115