Cisco 3130 Spezifikationen PDF herunterladen (Seite 25)

CHAPTER

1-1

Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference

OL-13271-06

Using the Command-Line Interface

The switches are supported by Cisco IOS software. This chapter describes how to use the switch

command-line interface (CLI) to configure software features.

For a complete description of the commands that support these features, see Chapter 2, “Cisco Catalyst

Blade Switch 3130 for Dell Cisco IOS Commands.” For information on the boot loader commands, see

Appendix A, “Cisco Catalyst Blade Switch 3130 for Dell Boot Loader Commands.” For information on

the debug commands, see Appendix B, “Cisco Catalyst Blade Switch 3130 for Dell Debug Commands.”

For information on the show platform commands, see Appendix C, “Cisco Catalyst Blade Switch 3130

for Dell Show Platform Commands.” For more information on Cisco IOS Release 12.2, see the Cisco

IOS Release 12.2 Command Summary.

For task-oriented configuration steps, see the software configuration guide for this release.

In this document, IP refers to IP version 4 (IPv4) unless there is a specific reference to IP version 6

(IPv6).

Accessing the Switch

You manage the switch stack and the stack member interfaces through the stack master (such as a

stacking-capable switch). You cannot manage stack members on an individual switch basis. You can

connect to the stack master through the console port of one or more stack members. You can also connect

to the stack master through the chassis management controller (CMC) to the internal Ethernet

management port. Be careful with using multiple CLI sessions to the stack master. Commands you enter

in one session are not displayed in the other sessions. Therefore, it is possible to lose track of the session

from which you entered commands.

Note We recommend using one CLI session when managing the switch stack.

If you want to configure a specific stack member port, you must include the stack member number in

the CLI command interface notation. For more information about interface notations, see the

“Configuring Interfaces” chapter in the software configuration guide for this release.

To debug a specific stack member, you can access it from the stack master by using the session

stack-member-number privileged EXEC command. The stack member number is appended to the system

prompt. For example,

Switch-2# is the prompt in privileged EXEC mode for stack member 2, and the

system prompt for the stack master is

Switch. Only the show and debug commands are available in a

CLI session to a specific stack member.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 106 107

Keine Kommentare

Cisco 3130 Spezifikationen Seite 25