Cisco 6050 Betriebsanweisung PDF herunterladen (Seite 29)

McAfee® IntruShield® IPS 4.1 Attaching Cables to the M-6050

M-6050 Sensor Product Guide Cabling for TAP mode

1 Plug the cable appropriate for use with your Gigabit Ethernet into one of the ports

labeled xA (for example, 1A).

2 Plug another cable into the peer of the port used in Step 1. This port will be

labeled xB (for example, 1B).

3 Connect the other end of each cable to the network devices that you want to

monitor. (For example, if you plan to monitor traffic between a switch and a

router, connect the cable connected to 1A to the switch and the one connected to

1B to the router.)

Cabling for TAP mode

The M-6050 sensor’s Gigabit Ethernet ports must be used with a 3rd party external

tap.

Note: For a list of approved 3rd party vendors, see the KnowledgeBase at

https://mysupport.mcafee.com

External tap mode requires a port pair (for example, 1A and 1B).

To connect the sensor to the devices you want to monitor in external tap mode:

1 Plug the cable appropriate for use with your Gigabit Ethernet port into one of the

ports labeled xA (for example, 1A).

2 Plug another cable into the other port labeled xB (for example, 1B).

3 Connect the other end of each cable to the tap.

4 Connect the network devices that you want to monitor to the tap.

Cabling for SPAN or hub mode

For the M-6050 sensor, monitoring in SPAN or hub mode occurs in in-line fail-open

mode. When you monitor in SPAN or hub mode, you do not need to use a port pair.

You can use single ports. To connect an M-6050 to a SPAN port or hub, plug an LC

fiber-optic cable into one of the modules and connect the other end of the cable to the

SPAN port or the hub.

Note: See Cable types for routers, switches, hubs, and PCs to determine which

cable type to use with which type of network device.

Cabling the Failover interconnection ports

Failover requires connecting two identical M-6050 sensors (same model, same

software) using an interconnection cable or cables.

Gigabit ports 4A is the interconnection port on the M-6050. A failover cable is the

only additional hardware required to support failover communication between two M-

6050 sensors.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35

Keine Kommentare

Cisco 6050 Betriebsanweisung Seite 29