Cisco 6050 Betriebsanweisung PDF herunterladen (Seite 27)

McAfee® IntruShield® IPS 4.1 Attaching Cables to the M-6050

M-6050 Sensor Product Guide Cabling the Monitoring port

2 Connect the other end of the cable to the network device (for example, hub,

switch, router) that in turn connects to the Manager server.

Note: To isolate and protect your management traffic, McAfee strongly

recommends using a separate, dedicated management subnet to interconnect the

sensors and the Manager.

Cabling the Monitoring port

Connect to the network devices you will be monitoring via the sensor Monitoring

ports. You can deploy sensors in the operating modes shown in the following table.

Cabling instructions for the sensor Monitoring ports are shown on the pages

indicated.

To cable the M-6050 in this mode... See...

In-line mode (fail-closed) Cabling for in-line mode

In-line mode (fail-open) Using fail-open hardware

External tap mode Cabling for TAP mode

SPAN or Hub mode Cabling for SPAN or hub mode

Failover Cabling the Failover interconnection ports

Using peer ports

All full-duplex sensor deployment modes require the use of two peer monitoring ports

on the sensor. On the sensors, the numbered ports are wired in pairs to

accommodate the traffic.

The following XFP 10 Gigabit Ethernet ports and SFP Gigabit Ethernet ports are

coupled and must be used together:

Port Pairs (and Transceiver Type)

1A and 1B (XFP)

2A and 2B (XFP)

3A and 3B (XFP)

4A and 4B (XFP)

5A and 5B (SFP)

6A and 6B (SFP)

7A and 7B (SFP)

8A and 8B (SFP)

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 33 34 35

Keine Kommentare

Cisco 6050 Betriebsanweisung Seite 27