Cisco Router IOS XR Bedienungsanleitung PDF herunterladen (Seite 84)

Cisco IOS XR Training Page 84

And our IS Type

RP/0/RSP0/CPU0:R1(config-isis)#is-type level-2

Set the loopback interface into ISIS and place it in PASSIVE mode

RP/0/RSP0/CPU0:R1(config-isis)#int loop0

RP/0/RSP0/CPU0:R1(config-isis-if)#passive

RP/0/RSP0/CPU0:R1(config-isis-if)#address-family ipv4 un

RP/0/RSP0/CPU0:R1(config-isis-if-af)#exit

Now for g0/1/0/11

RP/0/RSP0/CPU0:R1(config-isis-if)#int g0/1/0/11

RP/0/RSP0/CPU0:R1(config-isis-if)#address-family ipv4 unicast

RP/0/RSP0/CPU0:R1(config-isis-if-af)#exit

And finally, commit our changes.

RP/0/RSP0/CPU0:R1(config-isis-if)#commit

Fri Apr 20 01:02:31.714 UTC

Now, lets get PE2 setup the same way:

RP/0/RSP0/CPU0:R2(config)#router isis Core

RP/0/RSP0/CPU0:R2(config-isis)#net 49.0000.0000.0002.00

RP/0/RSP0/CPU0:R2(config-isis)#is-type level-2

RP/0/RSP0/CPU0:R2(config-isis)#int loop0

RP/0/RSP0/CPU0:R2(config-isis-if)#passive

RP/0/RSP0/CPU0:R2(config-isis-if)#address-family ipv4 u

RP/0/RSP0/CPU0:R2(config-isis-if-af)#exit

RP/0/RSP0/CPU0:R2(config-isis-if)#exit

RP/0/RSP0/CPU0:R2(config-isis)#int g0/1/0/11

RP/0/RSP0/CPU0:R2(config-isis-if)#address-family ipv4 un

RP/0/RSP0/CPU0:R2(config-isis-if-af)#exit

RP/0/RSP0/CPU0:R2(config-isis-if)#commit

Ok, lets check our ISIS neighbors

RP/0/RSP0/CPU0:R2#sh isis neighbors

Fri Apr 20 01:10:31.813 UTC

IS-IS Core neighbors:

System Id Interface SNPA State Holdtime Type IETF-NSF

R1 Gi0/1/0/11 6c9c.ed26.ab91 Up 22 L2 Capable

Total neighbor count: 1

RP/0/RSP0/CPU0:R2#

Yup, all neighbored up. Time to check the routes:

RP/0/RSP0/CPU0:R2#sh ip route isis

Fri Apr 20 01:10:54.269 UTC

i L2 150.1.1.1/32 [115/10] via 150.1.12.1, 00:07:06, GigabitEthernet0/1/0/11

RP/0/RSP0/CPU0:R2#

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 104 105

Keine Kommentare

Cisco Router IOS XR Bedienungsanleitung Seite 84