Cisco Wide Area Application Engine 612 Bedienungsanleitung PDF herunterladen (Seite 6)

80 Chapter 4: Network Integration and Interception

Example 4-3 shows a basic EtherChannel conﬁguration.

You should observe the following limitations when conﬁguring EtherChannel in WAAS:

• Both interfaces in the channel group must run at the same speed.

• Access control lists (ACL) are still applied to each physical interface.

The load-balancing algorithm used for distributing trafﬁc across the EtherChannel is

conﬁgured using the following command:

port-channel load-balance

dst-ip

dst-mac

| round-robin

The command is conﬁgured globally and applies to all PortChannels on the WAE.

To check the status of the PortChannel interface, use the show interface PortChannel

channel-number command. Example 4-4 demonstrates the output of this command.

Example 4-3 WAE EtherChannel Conﬁguration

interface PortChannel 1

description ** EtherChannel Link to Switch ABC ***

ip address 10.10.10.5 255.255.255.0

exit

interface GigabitEthernet 1/0

channel-group 1

exit

interface GigabitEthernet 2/0

channel-group 1

exit

Example 4-4 WAAS show interface PortChannel Output

AST6-CCO-01# show interface PortChannel 1

Interface PortChannel 1 (2 physical interface(s)):

GigabitEthernet 1/0 (active)

GigabitEthernet 2/0 (active)

---------------------

Type:Ethernet

Ethernet address:00:11:25:AB:43:32

Internet address:10.88.80.130

Broadcast address:10.88.80.255

Netmask:255.255.255.128

Maximum Transfer Unit Size:1500

Metric:1

Packets Received: 815996

Input Errors: 0

Input Packets Dropped: 0

Input Packets Overruns: 0

Input Packets Frames: 0

1 2 3 4 5 6 7 8 9 10 11 ... 40 41

Kommentare zu diesen Handbüchern

Keine Kommentare

Cisco Wide Area Application Engine 612 Bedienungsanleitung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Cisco Wide Area Application Engine 612