Cisco uBR904 Bedienungsanleitung PDF herunterladen (Seite 12)

12 Release Notes for Cisco uBR904 Cable Access Router for Cisco IOS Release 11.3 NA

Caveats for Release 11.3(1) through 11.3(10)NA.

this level of command by ISM, and must possess the ENABLE mode password. If the router is

controlled by TACACS+, the ISM user must have a TACACS+ User ID and Password to issue

enable level commands.

show user : command has been modiﬁed : the user ﬁeld is ﬁlled up by the host name.

Two options have been added to the following commands : sna host and dspu host.

The options are: no-enable and high-security.

Conﬁgure these options with focalpoint.

no-enable : when this is set, it does not allow enable command from the host

high-security : when this is set, it allows the following commands in USER mode. (PRIVILEGE

mode is not affected by this option.) You must enter all these commands in full or else the

command will not be allowed (that is, sh versi is not allowed for show version)

• CSCdm45535

C7500 router can erroneously detect output stuck conditions causing interfaces to reset or

perform cbus restarts for no apparent reason. This causes all IPs in the router to reset.

DECnet

• CSCdk23805

When decnet accounting is implemented, it’s possible for the router to crash depending on the

amount of connections.

• CSCdm28939

When you are conﬁguring Decnet on a router, you can specify an Address Translation Gateway

(ATG) network number in the range 0 to 3. If the ATG-network-number is speciﬁed incorrectly

while conﬁguring an interface, the router will reload.

If the ATG-network-number is not required the problem will not occur.

If the ATG-network-number is required, then a workaround is to ensure that the

ATG-network-number speciﬁed when enabling an interface matches the ATG-network-number

speciﬁed when decnet routing is enabled globally; for example:

decnet 1 routing 2.3 interface ethernet 0/0 decnet 1 cost 5

EXEC and Conﬁguration Parser

• CSCdm39355

If the length of the entire command after completion exceeds PARSEBUF, then the router crashes

Fix: Don’t allow the "command completion" if it exceeds PARSEBUF

IBM Connectivity

• CSCdm30793

A Cisco 7206 conﬁgured for dlsw priority peers may crash with a bus error in Release 11.3(9)T.

Workaround: None.

• CSCdm39124

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

Keine Kommentare

Cisco uBR904 Bedienungsanleitung Seite 12