Cisco uBR904 Bedienungsanleitung PDF herunterladen (Seite 11)

Release Notes for Cisco uBR904 Cable Access Router for Cisco IOS Release 11.3 NA 11

Caveats for Release 11.3(1) through 11.3(11)NA

This section describes possibly unexpected behavior by Release 11.3(11)NA. Unless otherwise

noted, these caveats apply to all 11.3 releases and platforms up to and including Release

11.3(11)NA.

Miscellaneous

• CSCdm47012

The latest versions of Smart Modular and Sharp Flash cards used to store Diagnostics and IOS

SW images can report unrecoverable write errors.

Affected Flash cards use a new Sharp (LH28F016SCT) chip set. The original Smart Modular and

Intel Flash cards are not affected.

Affected platforms are 7200 and all derivatives, 7500, GSR, and maybe others.

There is no workaround. If the problem occurs, try to reformat the Flash, store less images, or try

storing images in a different order. This may help under some circumstances.

• CSCdm68266

When running 11.3.10NA image, ingress gw can display wrong cause code.

• CSCdm68546

This ﬁxes CM status display in CMTS when the modem goes ofﬂine with BPI turned on and key

expiration.

Caveats for Release 11.3(1) through 11.3(10)NA.

This section describes possibly unexpected behavior by Release 11.3(10)NA. Unless otherwise

noted, these caveats apply to all 11.3 releases up to and including Release 11.3(10)NA. For

additional caveats applicable to Release 11.3(10)NA, see the caveats sections for later 11.3 releases.

The caveats for later releases precede this section.

All the caveats listed in this section are resolved in release 11.3(11)NA.

Access Server

• CSCdm50856

The sh modem command on an AS5200 router has different results from snmpwalk of the

cmInitialLineConnections variable deﬁned in CISCO-MODEM-MGMT-MIB. The IOS is

11.3(8)T1.

Basic System Services

• CSCdk80230

Certain Internetwork Status Monitor (ISM) NetView users can issue non-enable mode

commands without router authentication. Users accessing the router through NetView must be

authenticated through NetView’s security methods, which can include RACF and SAF.

Mainframe users can be restricted from issuing any router commands by the restriction of the

RUNCMD within NetView. Users issuing enable mode commands must be authorized to issue

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Keine Kommentare

Cisco uBR904 Bedienungsanleitung Seite 11